FranceElevatinOverloaded elevators do not operate: The load of elevators is limited, and if they are overweight, they will alarm and generally cannot be started. Most passengers can also voluntarily exit.
When encountering abnormal elevator operation, the overall noise can be reduced by 5-10db (A) Low energy consumption. From the working principle of permanent magnet synchronous motors, it can be seen that their excitation is achieved by permanent magnets, and there is no need for the stator to provide additional excitation current. Therefore, the power factor of elevators can reach a very high level. At the same time, the rotor of the motor has no current and there is no problem of electronic loss. Generally it reduces consumption by 45% -60% compared to asynchronous motors. Due to the lack of low efficiency and high energy consumption worm gear transmission pairs, but automatically resumes operation after a few minutes: The elevator (escalator) has been running for too long energy consumption is further reduced.
The elevator suddenly opens the door and does not move after leveling, and the motor overheats. To prevent burning out, the motor cools down and automatically resumes operation.
.The elevator suddenly opens the door and does not move after leveling, but automatically resumes operation after a few minutes: The elevator (escalator) has been running for too long, and the motor overheats. To prevent burning out, the motor cools down and automatically resumes operation.
When accidentally trapped in an elevator, one should remain calm,FranceHousehold sightseeing elevator, press the alarm bell inside the elevator, and call the elevator emergency rescue phone or community property phone for help. Do not open doors or mess with buttons, and patiently wait for rescue.
These phenomena are not elevator malfunctions. When the elevator is fully loaded, the elevator does not stop: to avoid overloading, the elevator car no longer responds to the next station's outbound call.
Will the elevator quickly fall during a power outage& mdash;& mdash; Some movies and TV dramas often mislead the public into thinking that if the elevator loses its power, it will lose control and engage in falling movements.
Attention: The elevator consists of two main parts: mechanical and electrical. If the elevator is not maintained on a daily basis, its safety cannot be guaranteed. If the elevator needs to be refueled without refueling, it will cause wear and tear on the mechanical components of the elevator, greatly shortening its service life and preventing normal use of the elevator.
The elevator suddenly opens the door and does not move after leveling, but automatically resumes operation after a few minutes: The elevator (escalator) has been running for too long,FranceTheater stage lifting platform, and the motor overheats. To prevent burning out, the motor cools down and automatically resumes operation.
Inspection requirements.Household elevators must be regularly maintained to confirm their safety and whether they can continue to operate, while also repairing any faults and hidden dangers found.
These phenomena are not elevator malfunctions. When the elevator is fully loaded, the elevator does not stop: to avoid overloading, the elevator car no longer responds to the next station's outbound call.
The braking system of the elevator is usually closed, which means it is in the braking state when there is no power, and only when it needs to be turned on, will the power turn on the brakes. So as soon as there was a power outage,FranceSecond floor household elevator, it is cut off
The difference between home elevators and ordinary public elevators is that the focus of home elevators and ordinary public elevators is different, with some indicators significantly reduced. For example, the load capacity of home elevators does not exceed 400kg, which is much lower than that of ordinary public elevators. Home elevators do not need to consider the issue of passenger flow, and running smoothly.
quality.Slide elevators are installed inside buildings and are often used parallel to buildings and sidewalks
The compensation chain and rope shall not collide with the shaft or other components during the operation of the elevator.
As elevator people ensuring safety. The lifting speed is generally between 0.3 to 0.4m/s, let's talk about elevator and elevator safety knowledge: The elevators we currently use include box type passenger elevators, escalators, and dedicated cargo elevators. Dedicated cargo elevators are installed due to special needs, and we don't use many of them. Now, let's take a look at the safety knowledge of box type passenger elevators and escalators: When we take escalators, Be sure to follow the safety instructions when riding on the elevator. Do not crowd or play around, hold onto the elevator firmly, fasten your shoelaces, and avoid getting them caught up.
France.The seat elevator person sits on a chair driven by an electric motor, and the button on the chair handle causes the power drive device at the bottom of the chair to drive the person chair up and down along the guide rail of the staircase railing
Passengers wearing long skirts and strapping sandals when riding on the escalator should try to stand slightly in the middle of the escalator to prevent shoes and clothing from being drawn into the escalator and causing danger, and to prevent skirts or pants from getting stuck.
2. Different types of civil engineering traction elevators, screw elevators, and hydraulic elevators have different requirements for civil engineering. Common traction elevators require a certain amount of hoistway space, steel structure hoistways, and glass curtain walls to create sightseeing elevators; The depth of the pit should be at least 50cm or more; Additionally, there are certain requirements for the height of the top floor.