which have the advantages of beautiful appearance, small volume, light weight, smooth lifting, safety and reliability.
Check the rollers, intermediate shafts, and bearings; Oil cylinder pin and bearing; Equality and wear of the hinge shaft and bearings of the boom; Fill the above components with oil. The service life of bearings can also be greatly enhanced.
France.Usage conditions: Electric elevators are suitable for use indoors or outdoors without wind (or gentle breeze), and cannot be used when the wind force is above level three; Platforms above five meters should be tied with safety ropes to ensure safety. Operating temperature; 20℃—& mdash;+ Hydraulic oil of the corresponding brand should be used when working between 40 ℃ and below 0 ℃; Try to operate on a solid and flat road.
Equipped with a manual descent valve for emergency descent in case of power outage.
.Blow out the plunger with compressed air, then install it and reinstall it.
The guardrail structure is integral and collectible, making it extremely simple and convenient to operate.
Remove and disassemble the lowering valve, blow the valve core clean with compressed air, and then reinstall it.
Firstly, for the monthly maintenance of the elevator, it is necessary to pay attention to the following points: add some oil to each part to extend the service life of the bearings.
Single group high-strength mast elevator, with light weight and good maneuverability, suitable for single person operation.
Where is good.We are well aware of the harm of pressure, but how can we prevent water from seeping into the hydraulic system of the elevator? After reading this article, you may know that oil contains excessive water impurities, which can rust the hydraulic components of the elevator, emulsify and deteriorate the oil,FranceHydraulic elevator lifting platform, reduce the strength of the oil film, and accelerate mechanical wear. In addition to preventing water impurities from invading during maintenance, it is also important to note that when the oil storage tank is not in use the cover should be tightened and placed upside down; Oil with high water content needs to be filtered multiple times, and the hydraulic oil of the elevator that is filtered each time needs to be replaced with a dry filter paper. In the absence of specialized instruments for detection, the oil can be dropped onto the hot iron plate, and no steam can be emitted before being added immediately. So when repairing the hydraulic system of aluminum alloy be careful of the entry of moisture!
Equipped with a manual descent valve for emergency descent in case of power outage.
After the elevator is lifted, it is necessary to fully study the maintenance manual of the elevator and do a good job in use and maintenance. In the detection of various indicators of the elevator, it is necessary to follow the regulations and ensure that the elevator is idle.
It is strictly prohibited to run the engine for a long time in a closed garage. The exhaust gas from the elevator engine contains carbon monoxide. This is a toxic gas that has been exposed to low concentrations of carbon monoxide for a long time. It can cause symptoms such as headache, shortness of breath, nausea and vomiting, body weakness and dizziness, psychological confusion, and even brain damage. In severe cases, such as starting the engine of the equipment in the garage.
Supply chain quality management.Elevators have the advantages of beautiful appearance, small size, light weight, balanced lifting, safety and reliability, and are widely used in factories, hotels,FranceSpecial hydraulic lifting platform for shopping malls, restaurants, stations airports, theaters, exhibition halls, and other places. They are a good safety companion for maintenance, painting, decoration, replacement of lighting fixtures, electrical cleaning and maintenance and other purposes. Adopting high-strength and high-quality specialized aluminum profiles, it has the advantages of beautiful appearance, small size, light weight, balanced lifting, safety and reliability.
Curved arm elevator: a lifting device used for high-altitude operations, which can cross obstacles for high-altitude operations. When the platform is lifted to any position, it can operate while walking, with a compact structure and flexible turning. The width of its site can ensure that the equipment enters narrow passages and crowded working areas. The backup power device can operate the work platform to reset, and is a convenient transportation method that can be towed to any place. Easy to identify operation panel, multiple mechanical,FranceHydraulic lifting platform factory, electrical, and hydraulic safety protection, advanced integrated hydraulic and electrical integrated system. The curved arm aerial work vehicle is widely used for installation, maintenance, and climbing operations in industries such as municipal administration, electricity, street lighting, advertising, communication, photography, landscaping, transportation, docks, airports and ports, and large industrial and mining enterprises.
The person in charge of the work should not only inspect the condition of the vehicle and the operators, but also be responsible for checking the terrain environment and whether the descent meets the requirements of safety technical measures or pre developed work plans. If there is any discrepancy, corresponding elevator measures should be formulated before starting work.
France.In modern society, there are many high-altitude work projects, and their danger is not only related to construction management and personnel quality, but also to the working environment and equipment used in construction. Therefore, high-altitude work equipment has received more and more attention with continuous development and innovation in lifting and lowering, and has been trusted and used by customers.
What are the advantages of elevators? Many customers, when consulting, thinking that their company lacks a machine that can work at heights. Is it better to use a regular ladder or a lifting platform? But we can firmly tell you that some heights of ordinary ladders are limited, and instability in high altitude can easily lead to accidents. And mobile elevators, with convenient lifting and flexible movement, are also rare safety tools. The types of high-altitude work platforms commonly needed by factories or companies are scissor forks and elevators. Today, with a compact structure and reliable performance.