Larosh on the Yonghe RiverSmall car electric elevatorThe demonstration effect in the industry has achieved results

announcer:hp935HP175192871 release time:2024-05-28 13:29:34

The L distance depends on the selected wall mount model.

The full height landing door should meet the following requirements: the net height of the landing door opening should not be less than 0m. In special circumstances, when the net height of the building entrance is less than 0m, but in any case, the net height of the lower door opening is not less than 8m. (Article 1 of GB26557-2011)

Larosh on the Yonghe River.Stop.

High lifting height, using side mounted oil cylinders, stable operation, noise free easy maintenance, and longer service life.

.The L distance depends on the selected wall mount model.

Chain type electric lifting mechanism: With a good guiding mechanism, it can ensure that the equipment does not tilt during operation. Gear and rack electric lifting mechanism: precise transmission and high cost.

The end height of the guide rail frame above the high attachment point should comply with the provisions of the user manual.


Larosh on the Yonghe RiverSmall car electric elevatorThe demonstration effect in the industry has achieved results



The safety distance between the outer edge of the upper part of the landing door and the moving parts of the electric elevator during normal operation should not be less than 0.75m; If the rated speed is not greater than 0.7m/s, the safety distance can be 0.40m.

The pressure joint between the pipe joint and the rubber hose fails prematurely, causing oil leakage or pipe explosion. The oil temperature rises due to frequent action of the overflow valve.

Every theater is a public place with a large number of people, and safety considerations should be taken into account in stage design. According to relevant national regulations, in order to prevent accidents caused by the crushing of electric elevators or improper control by drivers. Electric elevators should be equipped with the following necessary safety devices to ensure that the car of the electric elevator stops rising or falling in a timely manner.

Development Curriculum.Secondly, for the replacement of hydraulic oil on the lifting platform, it is recommended to replace it every three months. If the frequency of use is not high, it can be replaced once a year. The hydraulic oil must be clean, and after changing the hydraulic oil, it must be automatically lifted and lowered 2 to 3 times to ensure that the air in the oil cylinder is completely discharged, maintain sufficient space, and ensure that the lifting platform can be lifted to the rated lifting height.

The use of a lifting platform as a tool for storing performance blankets, soft scenery, etc. In some theaters, there is a soft scenery storage lifting platform located at an appropriate location on the stage for the storage of blankets, soft scenery,Larosh on the Yonghe RiverGuide rail electric elevator,Larosh on the Yonghe RiverSubminiature electric elevator, etc.

For customers to use and operate the lifting platform for a long time the editor briefly introduces how to maintain and repair the lifting platform: First of all, normal maintenance is mainly focused on prevention, especially if any damage or malfunction is detected and corrected or repaired in a timely manner. Careful inspection and maintenance at this time can save costs and avoid larger problems, resulting in costly repairs.


Larosh on the Yonghe RiverSmall car electric elevatorThe demonstration effect in the industry has achieved results



Braking. The brake limit switch for partial motion control of the electric hoist traction machine. Assembly that restricts the operation of the lift car when it is opened to a high or low position; If the limit switch controls the overtravel switch. When the car travels to a high or low position, it will take on the function of raising or lowering. In order to prevent the lift car from crashing or sinking, stage equipment should be dismantled with over travel switches that can cut off power and cannot be automatically reset, and installed in the machine room, rather than in the shaft; A buffer should be installed that can absorb the energy of the moving mechanism and reduce impact.

Where can I find it?.Setting requirements: Each landing entrance should be equipped with a landing door,Larosh on the Yonghe RiverElectric belt elevator, which should cover the opening with its full width, and should not open towards the lifting passage.

The top of the hanging cage is accessible; d) During installation/disassembly/maintenance/inspection of the device; e) Inside the hanging cage.

Every theater is a public place with a large number of people, and safety considerations should be taken into account in stage design. According to relevant national regulations, with a spacing of 200mm.