Saint EtienneE
Saint NazaireEit can ensure that the equipment does not tilt during operation. Gear and rack electric lifting mechanism: precise transmission and high cost.
The end height of the guide rail frame above the high attachment point should comply with the provisions of the user manual.
Saint Nazaire.Construction electric elevators must be equipped with lifting cages and reusable buffers
Chain type electric lifting mechanism: With a good guiding mechanism, and comply with regulatory requirements.
When the wall bracket adopts non matching standard products, design calculations should be carried out.
.The bearing capacity of the ground under the concrete foundation plate should be greater than 0.15Mpa.
From the above comparison, low noise, long service life, large load bearing capacity, and are relatively simple, making them suitable for use in stage equipment.
Setting requirements: Each landing entrance should be equipped with a landing door, which should cover the opening with its full width, and should not open towards the lifting passage.
News Abstract: The development of the lifting platform industry will continue to grow in recent years! With the continuous development of electric lifting machinery for high-altitude operations in recent years,Saint NazaireStage electric elevator, the products of electric lifting platform vehicles have been continuously improved, and various new technologies and materials have emerged, making the further development of lifting platform vehicles possible.
After the limit switch is activated, only professional personnel can restore the movement of the suspension cage.
The bearing capacity of the ground under the concrete foundation plate should be greater than 0.15Mpa.
property right.Horizontal lead screw mechanical electricity
Steel wire ropes, pulleys, and counterweight steel wire ropes shall comply with the following regulations: the characteristics of steel wire ropes shall comply with the requirements of General Purpose Steel Wire Ropes GB/T20118; Maintenance, wear, deformation, and corrosion of steel wire ropes
Mechanical devices controlled by cage movement should not be used to open or close the landing door.
When the horizontal distance between the edge of the cage and the edge of the landing or between the cage and the landing door is greater than 150mm and there is no effective protection from other structures, the side protection device for the landing entrance should be equipped.
Test method.Later, when there is a major malfunction of the lifting platform, it should be repaired by professional personnel as soon as possible. After the malfunction occurs, it should not be used again to avoid accidents, personnel and property losses.
Platform.
Protective measures should comply with regulatory requirements.
Saint Nazaire.When the wall bracket adopts non matching standard products,Saint NazaireMobile hydraulic electric elevator,Saint NazaireSmall electric mobile elevator, design calculations should be carried out.
Once again, weekly inspections should be conducted to check whether the connecting screws at various parts of the lifting platform are tightened, whether the sealing rings are damaged or ineffective, whether there is a lack of hydraulic oil, scissors, wiring and oil cylinder once a week to avoid dust and debris affecting normal operation.
The verticality of the guide rail frame should meet the requirements of the specifications.