New SongqiMicr
New SongqiElecoil pipe, and motor of the aluminum alloy electric elevator is good and whether there is any air leakage.
The spacing between wall brackets and the height of guide rails above the high attachment point should comply with the requirements of the user manual.
.The connection method and angle between the wall bracket and the building structure should comply with the requirements of the user manual.
Construction electric elevators should be equipped with cable guide frames and comply with regulatory requirements.
The landing door should meet the requirements of the specifications and achieve standardization.
The bearing capacity of the building structure at the attachment point of the wall bracket should meet the requirements specified in the user manual for construction electric elevators.
When a single steel wire rope is excessively stretched, the Electrical safety device shall stop the operation of the electric lift.
There is no need to set up a computer room above the shaft like an elevator, and the top floor height can be installed at least 2.5 meters.
market price.Flat screw mechanical electric lifting mechanism: The lifting platform of this structure has the advantages of small civil engineering coordination shallow foundation pit required, large stroke, stable operation, low noise, accurate positioning, and low cost. Adopting a horizontal screw drive and a scissor fork structure to achieve the lifting motion of the table,New South Memphis6 meter high electric elevator, it can be stopped arbitrarily within the range of travel.
The distance between the electric hoist and overhead line in Electrical safety construction shall meet the specification requirements, otherwise protective measures shall be taken.
Before operating the construction electric elevator, routine inspections should be carried out according to regulations and inspection records should be filled out.
Setting requirements: The layout and installation of all cables and wiring of electric elevators should be able to prevent mechanical damage.
Where can I find it?.Safety grounding device. In order to protect against electrical equipment. The metal casing of electrical equipment and the metal structure of electric elevators should be equipped with a safety grounding device. The grounding wire should operate multiple wires, and the neutral wire should not be arbitrarily held as a safety grounding wire. Its grounding resistance should not exceed 4 ohms; The power supply of the electric elevator can be cut off.
Construction electric elevators should be equipped with travel limit switches as follows: automatic reset type upper and lower limit switches should be installed on construction electric elevators,New South MemphisLight electric elevator, but the upper and lower limit switches should not be triggered as high
When a rigid 5000mm2 square or circular flat surface is applied with a normal force of 600N to either side of the door, the door may not meet the above requirements, otherwise protective measures shall be taken.
Electric elevators used in various places.
Once again, weekly inspections should be conducted to check whether the connecting screws at various parts of the lifting platform are tightened, whether the sealing rings are damaged or ineffective, whether there is a lack of hydraulic oil, and whether the oil cylinder is leaking. It is necessary to clean the lifting frame,New South MemphisNew electric elevator, scissors, wiring, and oil cylinder once a week to avoid dust and debris affecting normal operation.