KatanzaroIndoo
KatanzaroFlagpChain type electric lifting mechanism: With a good guiding mechanism,Katanzaro6-meter electric elevator, it can ensure that the equipment does not tilt during operation. Gear and rack electric lifting mechanism: precise transmission and high cost.
Low level doors should be equipped with interlocking devices that can verify their closed and locked positions. The action of this interlocking device should be at the entrance of the cage. Simple use should not interfere with the operation of the interlocking device. The attached wall bracket should use matching standard products. When the wall bracket cannot meet the requirements of the construction site, it should be designed separately. The design of the wall bracket should meet the requirements of component stiffness, strength, stability, etc.,KatanzaroElectric elevator cargo elevator, and the production should meet the design requirements.
Katanzaro.Is the water cooling and air cooling of the hydraulic station the same?
When the wall bracket cannot meet the requirements of the construction site, it should be designed and calculated separately.
.Setting requirements: The wall bracket should use the manufacturer's matching standard products.
Many theaters use a lifting platform as a vertical transportation tool for goods. The rear of the main stage or the end of the side stage in many theaters are equipped with a set container transportation lifting platform, which is used to vertically transport items from the ground to a designated location or even the stage plane. The lifting platform of the music pool is often used for transporting movable seats, etc.
Setting requirements: The installation and dismantling workers electricians, and other operators of construction electric elevators should have special construction operations.
The scissor type electric elevator is a widely used high-altitude operation special equipment. Its scissor mechanical structure ensures high stability of the lifting platform, wide working platform, and high bearing capacity, making the high-altitude operation range wider and suitable for multiple people to work simultaneously. It makes high-altitude operation more efficient and safer
In addition, when adding hydraulic oil,Katanzaro10 meter electric lifting platform, as some hydraulic oil manufacturers will choose hydraulic oil with poor quality. Hydraulic oil such as hydraulic lifting platforms not only cannot have any effect on folding arm elevators, but also affects the working efficiency of folding arm electric elevators due to deterioration issues.
The landing door should be in a normally closed state. Without the permission of the construction electric elevator driver, the landing door shall not be opened.
Marketing Department.Horizontal lead screw mechanical electricity
Double layer steel mesh: The diameter of the steel bars is 12mm, with a spacing of 200mm.
Manual pump: When the system malfunctions, the manual pump can be operated to pump high-pressure oil to raise the car to the nearest floor position
Setting requirements: The wall bracket should use the manufacturer's matching standard products.
Test conclusion.The foundation base or embedded parts should be fully embedded in the concrete foundation plate.
The shutdown device (emergency stop switch) should be non automatic reset type.
The spacing between wall brackets and the height of guide rails above the high attachment point should comply with the requirements of the user manual.
Katanzaro.Flat screw mechanical electric lifting mechanism: The lifting platform of this structure has the advantages of small civil engineering coordination, shallow foundation pit required, large stroke, stable operation, accurate positioning, and low cost. Adopting a horizontal screw drive and a scissor fork structure to achieve the lifting motion of the table it can be stopped arbitrarily within the range of travel.
When the door is closed, except for the gap between the lower part of the door that should not exceed 35mm, any through-hole and opening size related to the distance between any door and adjacent moving parts, as well as the gap around the door or the gap between parts, should comply with the provisions of Table 4 of GB 23821-2009.
Stage equipment safety door. To prevent personnel from extending their heads, hands, and feet out of the shaft and objects from falling into the vertical shaft. Its vertical position should be closed, its cabin should be full of doors, and the height of the hoistway (hall door) should not be less than 8 meters; The electric door opening and closing switches should be removed from the vertical and passenger compartment doors. In order to prevent accidents caused by vertical, passenger car doors, and car roof doors not being closed.; Door interlocks should be installed on both the vertical and passenger compartment doors.