SwarthFully se
SwarthDC elect
SwarthThree phIt is reported that a fixed electric elevator has good lifting stability and can only be used for fixed operations,SwarthMobile electric elevator, making high-altitude operations easier
There is no need to set up a computer room above the shaft like an elevator, and the top floor height can be installed at least 2.5 meters.
Swarth.Safety devices: Electric elevators for construction should be equipped with overload detection devices. When the load inside the cage exceeds 10% of the rated load capacity, the overload detection device will give a warning signal inside the cage,
Before installation, the installation unit should confirm that the foundation, foundation bearing capacity, embedded parts, and foundation drainage measures of the installed construction electric elevator and auxiliary heavy equipment comply with the requirements of the special construction plan for the installation and dismantling of the construction electric elevator based on the construction electric elevator foundation acceptance form, concealed engineering acceptance form, and concrete strength report.
.Use floor doors and cage door devices on construction sites where conditions permit.
High lifting height, using side mounted oil cylinders,SwarthElectric elevator 200kg,SwarthElectric hydraulic elevator, stable operation, noise free easy maintenance, the protective measures taken should comply with the specification requirements.
When the wall bracket adopts non matching standard products, design calculations should be carried out.
Normal operation starts. Click on this free download of construction technical information. Safety limit devices should be installed on electric elevators for construction, with upper and lower limit switches that are sensitive and reliable.
Tank oil temperature protection: When the oil temperature in the tank exceeds the standard setting value, hands and feet out of the shaft and objects from falling into the vertical shaft. Its vertical position should be closed, its cabin should be full of doors, and the height of the hoistway (hall door) should not be less than 8 meters; The electric door opening and closing switches should be removed from the vertical and passenger compartment doors. In order to prevent accidents caused by vertical, passenger car doors, and car roof doors not being closed.; Door interlocks should be installed on both the vertical and passenger compartment doors.
Swarth.Installation and dismantling personnel and drivers should hold certificates to work.
The L distance depends on the selected wall mount model.
Human improper operation is the main factor causing malfunctions in scissor type electric elevators. When stacking goods, electric elevators should stack the goods neatly, which is better than stacking them in the center of the cargo stacking area of the cargo elevator to avoid imbalance between the two ends of the stacking area. Eventually, during the operation of the electric elevator, it may cause the electric elevator to lose balance. After the goods are stacked completely, ropes should be used to lock the goods, so that they are not afraid of the goods during the lifting process; Careless; Scattered down