Zhang BoliAlum
Zhang BoliManu
Zhang BoliHomeElevators are used to transport firefighters, passengers, and fire-fighting equipment in the event of a fire. They are used to transport frozen goods in large cold storage or refrigeration workshops. However, they need to meet the requirements of sealing the door leaves and guide rails at the moving parts. Professional household elevators, villa household elevators, household elevator manufacturers, and small household elevators have stable, safe, reliable, and maintenance free performance, and their technical level has reached the domestic level,Zhang BoliSemi electric high-altitude reclaimer, Meet the advanced level of international similar products and immersion requirements
Elevator Tip 1: Why elevators can trap people? Every elevator door on each floor has a safety switch, which can trigger the elevator to shut down in case of any abnormality. The elevator getting stuck is actually when the system detects an abnormal signal and triggers a protective device, like braking to stop.
Zhang Boli.High transmission efficiency. Due to the use of permanent magnet synchronous motors for direct drive, the transmission efficiency can be improved by 20% -30%.
In daily life elevators are a commonly used tool that brings us a lot of convenience. But how much do you know about the types and safety knowledge of elevators?
.Passengers wearing long skirts and strapping sandals when riding on the escalator should try to stand slightly in the middle of the escalator to prevent shoes and clothing from being drawn into the escalator and causing danger, and to prevent skirts or pants from getting stuck.
The elevator suddenly descends to the bottom floor and resumes normal operation: After the elevator is powered off and reconnected, the leveling reference position needs to be re determined.
Overloaded elevators do not operate: The load of elevators is limited, and if they are overweight, they will alarm and generally cannot be started. Most passengers can also voluntarily exit.
Elevator Tip 1: Why elevators can trap people? Every elevator door on each floor has a safety switch,Zhang BoliFully electric high-altitude reclaimer, which can trigger the elevator to shut down in case of any abnormality. The elevator getting stuck is actually when the system detects an abnormal signal and triggers a protective device, like braking to stop.
Machine room power supply: The power supply should be three-phase 380V, 50HZ, and the lighting power supply should be single-phase 220V, 50HZ. The incoming line should be connected to the vicinity of the machine room entrance and equipped with an incoming socket. Specializing in product and renewable resource business, including: home elevator manufacturers
When accidentally trapped in an elevator, one should remain calm, press the alarm bell inside the elevator, and patiently wait for rescue.
Highly recommended.Overloaded elevators do not operate: The load of elevators is limited, and if they are overweight, they will alarm and generally cannot be started. Most passengers can also voluntarily exit.
These phenomena are not elevator malfunctions. When the elevator is fully loaded,Zhang BoliGrain hydraulic flipper, the elevator does not stop: to avoid overloading, the elevator car no longer responds to the next station's outbound call.
The elevator suddenly opens the door and does not move after leveling, but automatically resumes operation after a few minutes: The elevator (escalator) has been running for too long and the motor overheats. To prevent burning out, they may lose their balance and fall due to leaning against the skirt board on the side of the escalator, which does not move, but their feet move with the steps. Especially when carrying a lot of packages while taking the elevator, it is more likely to fall on the escalator due to the inability to hold the handrail properly. So, when riding on the escalator, we must stand firmly and support it well, and do not lean against the skirt board on the side of the escalator.
Signal method& mdash; When passengers ride in elevators with electric storage devices, PCs, and microcomputers, they first need to give the elevator a call signal on the floor they are on. After entering the elevator car, they also need to register the floor signal they want to go to. These signals will continue to appear, and the elevator signal must continuously record and arrange the execution order. This is the signal or logic technology of elevators, which was early used with simple collective selection&flash& mdash; Relays, PCs are mostly used for freight elevators and escalators, while passenger elevators use microcomputer systems, which significantly improve reliability anti-interference, and scheduling efficiency. Digital display of faults facilitates maintenance. Professional home elevator manufacturers and other products have a complete range of products that sell well both domestically and internationally. Our equipment has a long service life! The industry leader in product wire products, welcome to inquire
The difference between home elevators and ordinary public elevators is that the focus of home elevators and ordinary public elevators is different, with some indicators significantly reduced. For example, the load capacity of home elevators does not exceed 400kg, which is much lower than that of ordinary public elevators. Home elevators do not need to consider the issue of passenger flow, and the lifting speed is slower, ensuring safety. The lifting speed is generally between 0.3 to 0.4m/s, and running smoothly.
Zhang Boli.These phenomena are not elevator malfunctions. When the elevator is fully loaded, the elevator does not stop: to avoid overloading, the elevator car no longer responds to the next station's outbound call.
Mine elevators are used for transporting personnel and goods in mines. Special elevators are designed for special environmental conditions, such as explosion-proof anti-corrosion, and heat-resistant elevators
The braking system of the elevator is usually closed, which means it is in the braking state when there is no power, will the power turn on the brakes. So as soon as there was a power outage, the brakes closed and the elevator was braked in mid air. When the elevator descends abnormally, it is cut off