OrleansFactory lift cargo elevatorIntroduction to the composition and function of

announcer:hp779HP136589660 release time:2023-12-22 09:03:59

Guide rail elevator (also known as cargo elevator) is a non scissor fork type hydraulic lifting platform, mainly used in industrial buildings, restaurants, restaurants, warehouses, workshops, and other places where vertical cargo handling is required between two or more floors. The low height is particularly suitable for sites that are not suitable for digging pits on site. What issues should we pay attention to in these places where elevators are used?

Test the goods elevator every day to see if it can operate normally.

Orleans.Before using the machine, the staff should carefully check the hydraulic and electrical systems to ensure there is no leakage or bare leakage before using it.

It is strictly prohibited for personnel to climb up and down the floors by using the goods elevator privately.

.The water cooling of hydraulic stations is generally tubular water cooling,OrleansCargo elevator, and the type selection is based on the heat load to calculate the heat exchange area, while the air-cooled elevator is conducted using an air cooler, and the heat exchange capacity is calculated based on the heat load. Then, the type selection calculation is performed when the flow can be satisfied. Therefore, the two types of cooling are different, and there are significant differences. Long-term lifting and lowering of cargo elevator factory

Before installing the elevator, confirm whether the motor and the elevator are intact, and strictly check whether the dimensions of each part connecting the motor and the elevator match. Here are the dimensions and fit tolerances of the positioning boss, input shaft, and elevator groove of the motor.

Incorrect connection of the elevator motor When a coil, coil group, or one phase winding group is connected inversely, it can cause a serious imbalance in the three-phase current and cause the winding to overheat.


OrleansFactory lift cargo elevatorIntroduction to the composition and function of



Goods should be stacked well on the platform, and should not be tilted. When the goods elevator is lifting or lowering beyond the scope of the platform, no one should stand around to watch.

Small pneumatic or electric derusting, which uses the principle of friction generated by air compression or electromagnetic effects to polish and remove rust on the surface of a spiral elevator can be used for precision instrument push rods or for enterprises that require micro operation of spiral elevators.

The brake operators of each mechanism on the equipment should regularly check and adjust the clearance of the brake shoe and brake wheel, ensuring flexibility and reliability. Long term improvement of the elevator factory, a 20 year old brand with competitive prices and guaranteed quality!

Product survey.Carefully prepare a special construction plan for installation and construction, and provide safety technical disclosure to installation personnel.

Frequently check for water accumulation and humidity. It is inevitable for aerial vehicles to drive in rainy and snowy weather, or muddy roads. The bottom and some gaps and indoor floors are prone to sludge accumulation. If the owner does not clean them in a timely manner, this can cause moisture to hide. Therefore, activities in the outer edges of wheel hubs, doors, bottom corners of tree trunks, key holes, and wiper brackets, as well as other areas, should be regularly inspected, and the drainage holes in the doors and various parts should be kept unblocked to ensure that the car seat covers, such as humidity, carpets, prevent rust from forming parts.

In addition, it is strictly prohibited to use a hammer during installation to prevent excessive axial or radial force from damaging the bearings or gears. Be sure to tighten the mounting bolts before tightening the tension bolts. Before installation, clean the anti rust oil on the motor input shaft, positioning boss, and elevator connection parts with gasoline or zinc sodium water. Its purpose is to ensure the tightness of the connection and the flexibility of operation, and to prevent unnecessary wear and tear.


OrleansFactory lift cargo elevatorIntroduction to the composition and function of



It is good for aerial work vehicles not to cover their clothes and park outside. If it is windy and rainy,OrleansSimple lifting cargo elevator requires, the clothes will repeatedly slap the car paint, especially if the vehicle blows sand on the clothes, causing many fine scratches on them, as the paint will become black over time. In addition, when the wind does not directly spray powder or clean the mechanism on the sand, it should be washed with water and prevent the vacuum cleaner of the aerial work vehicle from scratching the sand particles on the paint surface.

Industry management.The common types of elevators will be briefly introduced here. I hope you can have a better understanding of this product. Currently, because many places need to use this kind of product with lifting function and flexible movement. Now this product can be said to be sold well in China, companies specializing in producing this type of product combine with extensive external publicity on the Internet, and then have a brief understanding of the model, performance, and price information of these products. They can purchase directly through the Internet.

The one-way valve is damaged. The one-way valve is designed to prevent oil return. If there is a problem, there will be some backflow, small and medium-sized enterprises are products with the idea of good quality and preferential prices.

Orleans.Scissor type fixed lifting platform is a transportation and loading equipment that transports goods from one height to another. After operation, the platform is level with the ground without occupying ground space and affecting passage passage.

Fixed elevator is a transportation equipment that directly lifts and loads goods from the ground. It is mainly used for goods transportation between height differences in production lines, material loading and unloading, component lifting during assembly of large equipment, fixed three-dimensional parking, and other places. So what is the new price for fixed elevators?

Different. (Specific bearing capacity and lifting height can be designed and customized according to user requirements)