TanobjegElectr
TanobjegMobileit is necessary to take time to prepare accordingly. At this time, it is necessary to provide timely feedback or communicate with the manufacturer. If a voltage range is used to detect the hydraulic lifting platform, it is necessary to turn on the power in this case. The circuit schematic is used to measure the electrical circuit. At this time, the voltage value can be measured and the voltage value can also understand where the fault point is. Therefore, in this case, it is necessary to learn to analyze.
The use of highlights is cost-effective. When aluminum alloy elevators were in the market, their price was also a significant highlight. Because manufacturers make reasonable and moderate pricing decisions in their daily processes,TanobjegHydraulic loading and unloading platform, it is well known that manufacturers generally consider manufacturing costs when pricing. and
.After working for 10000 hours, whether the sealing rings are damaged or ineffective weekly inspections should be conducted to check whether the connecting screws at various parts of the lifting platform are tightened, whether there is a lack of hydraulic oil, and whether the oil cylinder is leaking. It is necessary to clean the lifting frame, scissors, wiring, and oil cylinder once a week to avoid dust and debris affecting normal operation.
When working at heights exceeding 1.5 meters, safety nets or safety belts must be used.
Especially when its pipes are in use, they are quite boring and can roll, so in this case, they need to be blocked or tied tightly. This is relatively appropriate, so it is necessary to pay attention to these details during use. Especially for unmanned protective lifting platforms, it is not allowed to carry people during use, and it is strictly prohibited to carry people. If the electric lifting platform carries people during use, it is equipped with railings or anti crack valves, intermediate shafts,TanobjegMobile hydraulic loading platform, and bearings; Oil cylinder pin and bearing; Equality and wear of the hinge shaft and bearings of the boom; Add oil to the above components for maintenance of outdoor elevators and factory elevators. Extend the service life of bearings.
Inspection basis.High altitude work requires the use of tool bags, and heavier and larger high-altitude work tools should be hung on stable components and cannot be placed randomly to avoid the occurrence of high-altitude falling accidents.
Copyright © 2006-2022 Yan-wei.Net.All Rights Reserved.
Staying below high-altitude work sites is prohibited,TanobjegElectric hydraulic lifting platform, and safety nets or other protective devices should be installed below the work site to avoid injury from falling objects.
When the motor overheats, it should be stopped immediately, and after troubleshooting, it should continue to operate. The motor bearings should be in good condition.
Product range.If there are problems inside the elevator and electrical professionals are present, any components of the hydraulic system should be disassembled and repaired in a completely depressurized condition.
Of course, the hydraulic lifting platform uses a dual protection structure, which can make the work relatively safer. When lifting, an appropriate working surface can be selected, so that the lifting platform will be safer during operation. The process of operating the hydraulic lifting platform should be standardized, so that maintenance and debugging can be carried out before leaving the factory. At the same time, it can also ensure that all technical indicators can meet the design requirements, but it is necessary to connect the ground wire during use. Of course, the hydraulic electrical system does not need to be adjusted in this situation.
Website homepage
Tanobjeg.Hydraulic loading elevators must strictly carry out load-bearing operations in accordance with regulations. Otherwise, it may harm people and objects!
The use of highlights is cost-effective. When aluminum alloy elevators were in the market, their price was also a significant highlight. Because manufacturers make reasonable and moderate pricing decisions in their daily processes, it is well known that manufacturers generally consider manufacturing costs when pricing. and
Check the rollers intermediate shafts, and bearings; Oil cylinder pin and bearing; Equality and wear of the hinge shaft and bearings of the boom; Add oil to the above components for maintenance of outdoor elevators and factory elevators. Extend the service life of bearings.