WanghuaGrain u
WanghuaSingle Copyright © 2006-2022 Yan-wei.Net.All Rights Reserved.
When using the elevator, we should listen for any abnormal noise. If there is any abnormal noise,WanghuaPlatform lifting platform hydraulic, we should immediately stop using it to avoid serious damage to the elevator.
Wanghua.When using a hydraulic lifting cargo elevator, it is necessary to have corresponding inspection routes. If the route malfunctions and the joint becomes loose, it is necessary to turn it on or off properly. In this case, there may be short lines or damaged components. Using a table for inspection is relatively better.
Shafts must have split pins and be sufficient.
.After working for 10000 hours, repair the mechanical and electrical systems of the elevator.
When working at heights exceeding 1.5 meters, safety nets or safety belts must be used.
Check the rollers, intermediate shafts, and bearings; Oil cylinder pin and bearing; Equality and wear of the hinge shaft and bearings of the boom; Add oil to the above components for maintenance of outdoor elevators and factory elevators. Extend the service life of bearings.
Regularly check whether the operation of each mechanism is normal and whether there is any noise. If any faults are found, they must be promptly eliminated.
Especially when its pipes are in use, they are quite boring and can roll, so in this case, they need to be blocked or tied tightly. This is relatively appropriate, so it is necessary to pay attention to these details during use. Especially for unmanned protective lifting platforms, it is not allowed to carry people during use, and it is strictly prohibited to carry people. If the electric lifting platform carries people during use, it is equipped with railings or anti crack valves, which are mainly used to prevent the oil pipe from breaking or causing its workbench to fail during use and then descend.
Regularly check all wires and cables for damage, which is closely related to the advanced manufacturing technology of manufacturers. In fact,WanghuaShear difference hydraulic lifting platform, there are still many advanced processes that can be used nowadays. If used appropriately in daily production and manufacturing processes, it can still improve the quality and production efficiency of manufacturers' products to a certain extent. As for this type of loading and unloading platform, manufacturers use many special manufacturing processes during production which makes it highly stable in application.
Safety protection components, in order to ensure safety production,WanghuaElectric self hydraulic lifting platform, it is essential to install a lifting platform for proper protection. The main protective accessories include safety belts, guardrails protective covers, platform stairs, etc.
Secondly, for the replacement of hydraulic oil on the lifting platform, it can be replaced once a year. The hydraulic oil must be clean, and after changing the hydraulic oil, it must be automatically lifted and lowered 2 to 3 times to ensure that the air in the oil cylinder is completely discharged, maintain sufficient space, and ensure that the lifting platform can be lifted to the rated lifting height.
Regularly check all wires and cables for damage, and promptly wrap and replace the damaged parts.
Honest service.When working at heights exceeding 1.5 meters, safety nets or safety belts must be used.
When a hydraulic lifting platform malfunctions, it is necessary to take time to prepare accordingly. At this time, it is necessary to provide timely feedback or communicate with the manufacturer. If a voltage range is used to detect the hydraulic lifting platform, it is necessary to turn on the power in this case. The circuit schematic is used to measure the electrical circuit. At this time, the voltage value can be measured, and the voltage value can also understand where the fault point is. Therefore, in this case, it is necessary to learn to analyze.
Copyright © 2006-2022 Yan-wei.Net.All Rights Reserved.
Wanghua.When conducting high-altitude operations on dangerous edges such as roofs suspension bridges, or cliffs, guardrails or safety nets should be installed on the side facing the air, or safety belts or ropes should be used.
For homepage | add favorites | email | QQ: If you have any questions, please QQ us!
We