Lai YangDry type transformer MarketIndustry leader

announcer:hp122HP117294921 release time:2024-01-10 11:17:44

Sound, causing short circuit obstruction. If not handled properly, it will cause great damage.

High voltage fuse of transformer breaks one phase;

Lai Yang.Precautions for trial operation of power transformer manufacturers

Dry type transformer manufacturer

.There are also many problems to pay attention to in the preventive measures and process of dry-type transformer damping. What are the key effects and functions of dry-type transformer damping and the corresponding preventive measures? Let's master and consult in detail with the small editor of the dry-type transformer manufacturer.

For no-load impulse closing of transformer, pay attention to the following matters:

The technical specification of power consumption requires that the resistance of maintenance grounding wire shall be ≤ 4Ω, The resistor is generally more than 2000 & omega;, According to Ohm's law, when the insulating layer is damaged, the current is only 1 / 500 of the total current flow, so as to play a guarantee effect. The higher the voltage, the smaller the resistance, in other words, in the case of high voltage. We can care about the power transformer plant and master a lot of professional knowledge.


Lai YangDry type transformer MarketIndustry leader



Operation and maintenance management of oil immersed transformer

A kind of power engineering equipment that converts the working voltage and current according to the basic law of magnetic effect of current. In the whole process of power transmission and transformation of power engineering, it is necessary to carry out voltage transformation and blood pressure reduction according to the transformer to reduce the loss of electromagnetic energy in the whole process. Therefore the power consumption of the processing plant is all connected with 10kV switching power supply, it will inevitably cause the loss of voltage and output power. When transporting the same output power, the voltage loss is inversely proportional to the voltage, and the output power loss is inversely proportional to the square meter of voltage. The transformer is used to increase the voltage and reduce the closing damage.

During no-load test run, the transformer shall be connected with the working voltage from the switching power supply side,Lai Yang2500kVA dry type transformer, and then make the working voltage impulse closing.

Oil immersed transformer operation


Lai YangDry type transformer MarketIndustry leader



Avoid inadvertent damage of insulation during maintenance: when repairing the hanging core of power transformer, it shall be handled properly.

wholesaler.Due to careless transportation of the transformer and the thin high-voltage conductor,Lai YangLow voltage transformer, the transformer was disconnected by vibration (but there was no grounding device).

Once the insulation material of electrical equipment is overheated, the surrounding gas will cause a kind of odor. This kind of odor can be sniffed out by normal patrol staff. When you smell such odor during normal inspection you should carefully inspect the equipment and parts until you find out the cause.

A specific part of dry-type transformer is the hanging core of dry-type transformer. The hanging core of dry-type transformer is a vital component. How to carry out the hanging core?

Lai Yang.The iron core of power transformer is made of high-quality crystallized hot-rolled ferrite core,Lai YangDry type transformer scb13-1250kva, which is stacked at the 45 degree fully inclined multi-step interface. The surface is covered with epoxy resin adhesive cable sheath coating, which is resistant to corrosion and rust, and has sound insulation and noise reduction.

In the case of using dry-type transformer, customers must master the method of wiring. If there are problems in wiring, it is easy to cause common faults in application. So, what is the wiring mode of dry-type transformer?

The iron core of power transformer is made of high-quality crystallized hot-rolled ferrite core, which is stacked at the 45 degree fully inclined multi-step interface. The surface is covered with epoxy resin adhesive cable sheath coating, which is resistant to corrosion and rust, and has sound insulation and noise reduction.