FoggiaElectric belt elevatorAnalysis of the role played in the industry

The hydraulic oil enters the upper end of the hydraulic cylinder through the explosion-proof electromagnetic directional valve and the return oil from the lower end of the hydraulic cylinder returns to the oil tank through the balance valve, hydraulic control one-way valve, throttle valve, and explosion-proof electromagnetic directional valve. To ensure a smooth descent of heavy objects and safe and reliable braking a balance valve is installed on the return oil circuit to balance the circuit and maintain pressure, so that the descent speed does not change due to heavy objects. The throttle valve regulates the flow rate and the ascending and descending speed.

Low level doors should be equipped with interlocking devices that can verify their closed and locked positions. The action of this interlocking device should be at the entrance of the cage. Simple use should not interfere with the operation of the interlocking device. The attached wall bracket should use matching standard products. When the wall bracket cannot meet the requirements of the construction site,Foggia2 meter electric lifting platform, it should be designed separately. The design of the wall bracket should meet the requirements of component stiffness, strength, stability, and the production should meet the design requirements.

Foggia.Lower limit switch: In normal working state, before the suspension cage touches the buffer,FoggiaElectric mobile elevator, the lower limit switch first acts.

Model Example: Hanging Cage Specification: LABSC200/200TD3200x1500 Type I: 2900~3600 Type II: 2900~3600 Type V: 1800~250044003800 Technical Requirements: The load-bearing capacity of the foundation should be greater than P: P=(hanging cage weight+outer cage weight+total weight of guide rail frame+counterweight+load) x0.02 (kN).

.The angle between the wall bracket and the horizontal plane should comply with the requirements of the user manual.

Emergency manual valve: In case of power failure, it can cause the car to descend to the nearest floor position and open the door

The quality of the standard section should comply with the product manual and specification requirements.

Setting requirements: The foundation and foundation of the construction electric elevator should meet the requirements of the user manual. Before installing the construction electric elevator, the foundation should be inspected and accepted according to the requirements of the specifications. Only after passing the inspection can the installation be carried out.

The usual operation of landing and docking. The installation position of the upper limit switch should comply with the following: when the lifting speed is less than 0.8m/s, as specified in the above table.

When the foundation is set on the roof or floor structure, the bearing capacity of its supporting structure should be checked.

For customers to use and operate the lifting platform for a long time, the editor briefly introduces how to maintain and repair the lifting platform: First of all, normal maintenance is mainly focused on prevention, especially if any damage or malfunction is detected and corrected or repaired in a timely manner. Careful inspection and maintenance at this time can save costs and avoid larger problems, resulting in costly repairs.

Setting requirements: The layout and installation of all cables and wiring of electric elevators should be able to prevent mechanical damage.

Analysis project.Setting requirements: The guide rail should be rigid and flexible components such as wire ropes or chains should not be used.

We have all purchased the aluminum alloy electric elevator equipment, which is compact and easy to carry. Many garden style hotels,FoggiaElectric spiral rod elevator, hospitals, airports, and large parking lots also wear this equipment,

The spacing between wall brackets and the height of guide rails above the high attachment point should comply with the requirements of the user manual.

Foggia.Setting requirements: The installation and dismantling workers, electricians, and other operators of construction electric elevators should have special construction operations.

Setting requirements: The spacing of wall brackets along the vertical direction should comply with the provisions of the user manual.

When the wall bracket adopts non matching standard products, design calculations should be carried out.