Fengnan2 ton electric elevatorThe scope of application

Implementing multiple shifts of homework should fill in and submit records according to regulations.

Before installation, the installation unit should confirm that the foundation, foundation bearing capacity, embedded parts, and foundation drainage measures of the installed construction electric elevator and auxiliary heavy equipment comply with the requirements of the special construction plan for the installation and dismantling of the construction electric elevator based on the construction electric elevator foundation acceptance form, concealed engineering acceptance form,FengnanElectric elevator for exterior wall decoration, and concrete strength report.

Fengnan.There is a certain itinerary.

Flat screw mechanical electric lifting mechanism: The lifting platform of this structure has the advantages of small civil engineering coordination, shallow foundation pit required, large stroke, stable operation, low noise,FengnanElectric vertical elevator,FengnanElectric one ton elevator, and low cost. Adopting a horizontal screw drive and a scissor fork structure to achieve the lifting motion of the table, it can be stopped arbitrarily within the range of travel.

.There is no need to set up a computer room above the shaft like an elevator, and the top floor height can be installed at least 2.5 meters.

When the horizontal distance between the edge of the cage and the edge of the landing or between the cage and the landing door is greater than 150mm and there is no effective protection from other structures, the side protection device for the landing entrance should be equipped.

Setting requirements: The verticality deviation of the installation of the guide rail frame of the construction electric elevator should comply with the requirements of the user manual and specifications, as specified in the above table.

Electric elevators used in various places.

Setting requirements: Construction electric elevators should be equipped with a down travel (limit) switch. The down travel (limit) switch should be able to automatically stop the cage running at rated speed before reaching the lower limit switch.

When the horizontal distance between the edge of the cage and the edge of the landing or between the cage and the landing door is greater than 150mm and there is no effective protection from other structures, the side protection device for the landing entrance should be equipped.

Safety and health.Setting requirements: The spacing of wall brackets along the vertical direction should comply with the provisions of the user manual.

Setting requirements: Drainage measures should be set up for the foundation of construction electric elevators to ensure smooth drainage.

When the wall bracket adopts non matching standard products design calculations should be carried out.

Drivers of construction electric elevators should hold special construction operations and are not allowed to operate without a certificate.

Latest consultation.Protective measures should comply with regulatory requirements.

When adding hydraulic oil, the lifting platform should not exceed the high position we can extend the oil cylinder to the high position for filling. When filling, and then retract the oil cylinder back to the low position to check if the hydraulic oil level is lower than the low position, and maintain it between the two.

During the use period, the user unit should organize professional technical personnel to inspect the construction electric elevator monthly according to the standard requirements, the guide rail hydraulic lifting platform is superior in terms of product, civil engineering, and operating costs. The editor of the electric elevator will provide a detailed analysis: the advantages of the product are that the equipment bears a large load, can achieve multiple points, and can be controlled up and down floors to achieve safe use.

Installation and dismantling personnel and drivers should hold certificates to work.

Work is essential, and the main protective accessories include safety belts, guardrails, protective covers, platforms and stairs, etc.