InnisGuide rail electric elevatorTips for using

Drainage measures need to be considered around the foundation. (Drain the accumulated water on the foundation).

Setting requirements: Before starting work every day and changing shifts, the driver of the construction electric elevator should inspect the construction electric elevator according to the requirements of the user manual and specifications, record the inspection results, and report any problems found to the user unit.

Innis.When a single steel wire rope is excessively stretched,InnisElectric elevator factory, the Electrical safety device shall stop the operation of the electric lift.

Braking. The brake limit switch for partial motion control of the electric hoist traction machine. Assembly that restricts the operation of the lift car when it is opened to a high or low position; If the limit switch controls the overtravel switch. When the car travels to a high or low position it will take on the function of raising or lowering. In order to prevent the lift car from crashing or sinking, stage equipment should be dismantled with over travel switches that can cut off power and cannot be automatically reset, and installed in the machine room, rather than in the shaft; A buffer should be installed that can absorb the energy of the moving mechanism and reduce impact.

.The angle between the wall bracket and the horizontal plane should comply with the requirements of the user manual.

Secondly, for the replacement of hydraulic oil on the lifting platform,InnisElectric elevator 6 meters, it is recommended to replace it every three months. If the frequency of use is not high, it can be replaced once a year. The hydraulic oil must be clean, and after changing the hydraulic oil, it must be automatically lifted and lowered 2 to 3 times to ensure that the air in the oil cylinder is completely discharged, maintain sufficient space, and ensure that the lifting platform can be lifted to the rated lifting height.

The use of standard section connecting bolts should comply with the user manual and specification requirements.

When the foundation is set on the roof or floor structure, the bearing capacity of its supporting structure should be checked.

The upward movement of the hydraulic cylinder involves lifting heavy objects, and the pressure gauge reads the value when observing the pressure gauge

Protective measures should comply with regulatory requirements.

The cheapest.Secondly, the lifting platform is driven by electrical energy and lifted by the hydraulic system. During operation, it is necessary to avoid irregular operations. To ensure the normal and orderly operation of the lifting platform and achieve the ideal unloading level, timely inspection of various functions is essential.

Every theater is a public place with a large number of people, and safety considerations should be taken into account in stage design. According to relevant national regulations, which should cover the opening with its full width, and should not open towards the lifting passage.

safety requirements .The entrance of each landing platform must be equipped with a landing door, which must open towards the landing platform side, and the door bolt must be set on the side next to the construction electric elevator.

The installation position of the lower limit switch. The installation position of the lower limit switch should ensure that the contact plate triggers the switch when the rated load of the suspension cage decreases, causing the suspension cage to stop. At this time, the contact plate should also be close to the triggering of the lower limit switch

Setting requirements: The installation and dismantling workers, electricians, and other operators of construction electric elevators should have special construction operations.

Innis.Setting requirements: Each landing entrance should be equipped with a landing door, which should cover the opening with its full width, and should not open towards the lifting passage.

Double layer steel mesh: The diameter of the steel bars is 12mm with a spacing of 200mm.

Small safe operation distance: Circuit voltage (kV) of external power lines<11~1035~110220330~550 Small safe operation distance (m) 4681015 Setting requirements: A small safe distance should be maintained between the outer edge of the construction electric elevator and the edge of the external overhead power line.