Guenzburg Ladder type electric elevatorAnalysis of the reasons for being widely used

Speed limit wire rope switch. When the speed limit wire rope trips or breaks. Make the electric elevator unable to start.

Use floor doors and cage door devices on construction sites where conditions permit.

Guenzburg .Lowering platform,Guenzburg Multifunctional electric elevator, vehicle mounted lifting platform, self-propelled lifting platform diesel engine curved arm self-propelled lifting platform, folding arm lifting platform cylinder sleeve lifting platform, aluminum alloy lifting platform, and special

The angle between the wall bracket and the horizontal plane should comply with the requirements of the user manual.

.The entrance of each landing platform must be equipped with a landing door, which must open towards the landing platform side, and the door bolt must be set on the side next to the construction electric elevator.

Especially suitable for steel structured factories, which is used to vertically transport items from the ground to a designated location or even the stage plane. The lifting platform of the music pool is often used for transporting movable seats, etc.

Once again, weekly inspections should be conducted to check whether the connecting screws at various parts of the lifting platform are tightened,Guenzburg Electric hydraulic folding elevator, whether the sealing rings are damaged or ineffective,Guenzburg Electric elevator mobile type, whether there is a lack of hydraulic oil, and whether the oil cylinder is leaking. It is necessary to clean the lifting frame, wiring, and oil cylinder once a week to avoid dust and debris affecting normal operation.

Platform.

Setting requirements: The layout and installation of all cables and wiring of electric elevators should be able to prevent mechanical damage.

discount.Stage equipment safety door. To prevent personnel from extending their heads, hands, and feet out of the shaft and objects from falling into the vertical shaft. Its vertical position should be closed, its cabin should be full of doors, and the height of the hoistway (hall door) should not be less than 8 meters; The electric door opening and closing switches should be removed from the vertical and passenger compartment doors. In order to prevent accidents caused by vertical, passenger car doors, and car roof doors not being closed.; Door interlocks should be installed on both the vertical and passenger compartment doors.

The connection method and angle between the wall bracket and the building structure should comply with the requirements of the user manual.

The safety notice board for construction electric elevators should be prominently placed on the hanging cage for the rated load capacity and rated number of passengers of the construction electric elevator. It is strictly prohibited to use construction electric elevators beyond the rated load capacity or rated number of passengers.

It is reported that a fixed electric elevator has good lifting stability and can only be used for fixed operations, making high-altitude operations easier

Welcome to inquire.Use floor doors and cage door devices on construction sites where conditions permit.

Electric elevators should be regularly maintained and cleaned. During maintenance and cleaning, the bracket should be supported to prevent the electric elevator from overturning. Electrical and hydraulic systems should be maintained by professional personnel; When the battery level display is less than 40%

Protective measures should comply with regulatory requirements.

Guenzburg .Setting requirements: The installation and dismantling workers, electricians, and other operators of construction electric elevators should have special construction operations.

Setting requirements: The anti loosening and anti loosening parts between the connecting parts should comply with the provisions of the user manual and should not be replaced by other objects. For connecting bolts with pre tightening requirements, a torque wrench or special tool should be used to accurately tighten the bolts to the specified torque value according to the specified tightening sequence. When installing standard section connecting bolts, it is advisable to place the screw at the bottom and the nut at the top.

Setting requirements: The guide rail should be rigid and flexible components such as wire ropes or chains should not be used.