Maun380V to 66
Eagle fighterPThe insulating layer shaft and the connecting articles between the bell jar and the core shall be removed. If it is a hanging bell inspection,MaunWind power box transformer, it must also be changed to produce flexible connection.
Maun.How to make up oil for oil immersed transformer?
Power transformer manufacturer
.Naturally, if the oil immersed transformer catches fire, please don't panic. I firmly believe that the damage will be reduced to a lower level as long as the above methods are effectively rectified. Above is the general process and process that should be paid special attention to in the whole ignition process of the oil immersed transformer. When the oil immersed transformer catches fire, please be rational to make the oil immersed transformer safer and more efficient.
The bearing capacity of each load is different. Generally, dry-type transformer should operate under rated capacity, while oil transformer has better load working capacity.
The oil in the machinery and equipment of the oil storage tank shall generally stand for more than 8h before sampling; it is not necessary to stand when sampling on the running power transformer.
(I) the distance between the external contour of 10kV and below dry-type transformer and the surrounding guardrail or courtyard wall shall take into account the convenience of transportation and repair of dry-type transformer, and the distance shall not be less than 1m; At the angle with actual operation, the metal fence shall be grounded and a warning sign shall be hung at a prominent position.
When the operating oil is mixed with different types of new oil or used for oil, in addition to the accurate measurement of the cold filter point of the mixed oil, it is also necessary to carry out high and low temperature test and sludge test, and observe the sludge accumulation. The accumulation cannot be accessed. The results of the operation of the mixing template are not that the original oil is very poor, so it can be managed and used in a mixed manner.
When leaving the factory, the production and processing are not smooth and the sealing is poor. The common fault of oil leakage will be caused after the oil transformer is sealed for a period of time.
Word of mouth recommendation.Deterioration damage of transformer core insulation
The plastic shells of electrical products and office supplies are equipped with grounding wires. If the insulation layer is damaged and the shell is energized, the electric flow will leak into the earth along the installed grounding wires,MaunReactor and transformer,MaunPicture of power transformer, so as to achieve the purpose of safety, otherwise it will have an adverse impact on life safety.
Dry type transformer company
What is the wiring mode of dry-type transformer?
Equipment maintenance.Dry type transformer factory
The transformer manufacturer will introduce the efficiency of the transformer to you
How to reduce the failure of dry-type transformer?
Maun.The time difference between different steps of three-phase power switch of switching power supply shall be less than 10ms, the closing shall be maintained by high-voltage arrester, and the neutral line of transformer shall be reliably grounded (it shall be grounded immediately).
Falling foreign matters and piercing
Oil immersed transformer company