ZwallerElectri
ZwallerElectriThe full height landing door should meet the following requirements: the net height of the landing door opening should not be less than 0m. In special circumstances, when the net height of the building entrance is less than 0m, it is allowed to lower the height of the lower door opening,Zwaller10 meter electric elevator, but in any case, the net height of the lower door opening is not less than 8m. (Article 1 of GB26557-2011)
Especially suitable for steel structured factories, suitable for both indoor and outdoor installation.
Zwaller.And prevent it from starting normally. There should be no device that allows users to cancel warning signals.
Setting requirements: Before starting work every day and changing shifts, the driver of the construction electric elevator should inspect the construction electric elevator according to the requirements of the user manual and specifications, record the inspection results, and report any problems found to the user unit.
.The function of the lifting platform in a theater is roughly as follows: the main lifting platform arranged in the main performance area of the stage is mainly used to quickly change the scenery. Typically, with&quo; Product; In the music and dance theater stage arranged in a zigzag pattern, the lifting platform, side car platform,ZwallerDecoration electric elevator, and rear car turntable perform a rapid transformation of the entire or partial scene. This arrangement allows for rapid switching of three full sets.
Especially suitable for steel structured factories, suitable for both indoor and outdoor installation.
Double layer steel mesh: The diameter of the steel bars is 12mm, with a spacing of 200mm.
Setting requirements: The layout and installation of all cables and wiring of electric elevators should be able to prevent mechanical damage.
In addition to fixed modes,ZwallerElectric screw elevator, there are also types of car mounted mobile devices. As the name suggests, this type of lifting device is a combination of lifting equipment and car mounted systems. It is very flexible to move and of course, it is better to use it. For example, there are such lifting devices in airports, and car stations or sports stadiums may also be equipped with such devices, So the scope of the operation is not limited to a specific place but can be used wherever lifting operations are required. For example, when installing outdoor advertisements some advertisements are relatively high in height. At this time, mobile lifting equipment can be used to transport billboards or staff to the designated height for work. This type of equipment can also be divided into two types based on the driving mode: hydraulic lifting and electric lifting. The so-called hydraulic lifting is the use of hydraulic oil to drive and reach a specified height. The electric mode is driven by a motor or teeth to lift to a certain height. However, currently, hydraulic lifting platforms are more widely used.
The landing door should meet the requirements of the specifications and achieve standardization.
Manufacturing cost.The L distance depends on the selected wall mount model.
Setting requirements: The guide rail should be rigid and flexible components such as wire ropes or chains should not be used.
The distance between the electric hoist and overhead line in Electrical safety construction shall meet the specification requirements, otherwise protective measures shall be taken.
Secondly, for the replacement of hydraulic oil on the lifting platform, it is recommended to replace it every three months. If the frequency of use is not high, it can be replaced once a year. The hydraulic oil must be clean, and after changing the hydraulic oil, it must be automatically lifted and lowered 2 to 3 times to ensure that the air in the oil cylinder is completely discharged, maintain sufficient space, and ensure that the lifting platform can be lifted to the rated lifting height.
quality.Setting requirements: The installation and dismantling workers, electricians, and other operators of construction electric elevators should have special construction operations.
When charging, it is necessary to charge it in a timely manner. When the equipment is used for about 2 months (according to the actual frequency of use), and if any pin shaft is found
Pipeline rupture valve: When the hydraulic system pipeline ruptures and the car stalls and descends, it can automatically cut off the oil circuit and stop descent
Zwaller.With the continuous improvement of urbanization level in China, the number of high-rise buildings in urban areas has sharply increased, in order to meet the needs of the domestic market and the public, efforts will inevitably be made to design and produce high-altitude lifting platform vehicles.
The connection method and angle between the wall bracket and the building structure should comply with the requirements of the user manual.
Drainage measures need to be considered around the foundation. (Drain the accumulated water on the foundation).