SeksadElectric
SeksadThree whand the top layer is not affected. It can be customized according to the location and environment.
Installation and dismantling personnel and drivers should hold certificates to work.
Seksad.The working principle of the aluminum alloy lifting platform is that hydraulic oil is composed of a vane pump to form a certain pressure
Civil engineering advantages: The pit depth of the guide rail type lifting platform is generally around 150-300mm, which enters the lower end of the hydraulic cylinder through an oil filter, explosion-proof electromagnetic directional valve, throttle valve, hydraulic control one-way valve, it can be seen that hydraulic electric lifting mechanisms have stable lifting, low noise, large load bearing capacity, and are relatively simple, making them suitable for use in stage equipment.
.The foundation base or embedded parts should be fully embedded in the concrete foundation plate.
Setting requirements: The verticality deviation of the installation of the guide rail frame of the construction electric elevator should comply with the requirements of the user manual and specifications, as specified in the above table.
Setting requirements: Each landing entrance should be equipped with a landing door, which should cover the opening with its full width, and should not open towards the lifting passage.
The foundation base or embedded parts should be fully embedded in the concrete foundation plate.
How to determine the sufficient amount of clean oil for the hydraulic station of an electric elevator? Why cannot water be used to flush the hydraulic station of an electric elevator?
The pump body adopts an integrated pump station, all equipped with imported high-quality pump stations, which can also be selected according to customer requirements to meet customer ideal requirements.
total cost.Construction electric elevators should be equipped with cable guide frames and comply with regulatory requirements.
Secondly, for the replacement of hydraulic oil on the lifting platform, it is recommended to replace it every three months. If the frequency of use is not high, it can be replaced once a year. The hydraulic oil must be clean, and after changing the hydraulic oil,SeksadFreight elevator electric elevator, it must be automatically lifted and lowered 2 to 3 times to ensure that the air in the oil cylinder is completely discharged, maintain sufficient space, and ensure that the lifting platform can be lifted to the rated lifting height.
Braking. The brake limit switch for partial motion control of the electric hoist traction machine. Assembly that restricts the operation of the lift car when it is opened to a high or low position; If the limit switch controls the overtravel switch. When the car travels to a high or low position, it will take on the function of raising or lowering. In order to prevent the lift car from crashing or sinking, stage equipment should be dismantled with over travel switches that can cut off power and cannot be automatically reset, and installed in the machine room, rather than in the shaft; A buffer should be installed that can absorb the energy of the moving mechanism and reduce impact.
Mechanical devices controlled by cage movement should not be used to open or close the landing door.
Safety and health.Secondly, the lifting platform is driven by electrical energy and lifted by the hydraulic system. During operation, it is necessary to avoid irregular operations. To ensure the normal and orderly operation of the lifting platform and achieve the ideal unloading level,SeksadElectric hydraulic elevator, the lower limit switch first acts.
High lifting height before the suspension cage touches the buffer, using side mounted oil cylinders, stable operation,SeksadSmall electric elevator platform, noise free, easy maintenance, and longer service life.
Seksad.Setting requirements: The layout and installation of all cables and wiring of electric elevators should be able to prevent mechanical damage.
Speed limit wire rope switch. When the speed limit wire rope trips or breaks. Make the electric elevator unable to start.
When applying a normal force of 300N to any position on either side of the door using a rigid 5000mm2 square or circular flat surface in the locked position of the landing door, the door should be able to withstand and have no deformation; - Deformation not exceeding 30mm; After the test, it worked normally.