BakersfieldMobile electric elevatorRemember these five points of daily maintenance are no problem

With the continuous improvement of urbanization level in China the number of high-rise buildings in urban areas has sharply increased, and the height of buildings has also continued to grow. This has created a demand for high-altitude lifting platform vehicles. Therefore, in order to meet the needs of the domestic market and the public efforts will inevitably be made to design and produce high-altitude lifting platform vehicles.

Before installation, the installation unit should confirm that the foundation, foundation bearing capacity, embedded parts, and foundation drainage measures of the installed construction electric elevator and auxiliary heavy equipment comply with the requirements of the special construction plan for the installation and dismantling of the construction electric elevator based on the construction electric elevator foundation acceptance form, concealed engineering acceptance form, and concrete strength report.

Bakersfield.Do not move after lifting,BakersfieldSimple electric elevator, smooth lifting and low noise.

The setting of the cable guide frame should comply with the user manual and regulatory requirements.

During the use period, the user unit should organize professional technical personnel to inspect the construction electric elevator monthly according to the standard requirements,BakersfieldDedicated electric elevator, and record the inspection results.

Operating cost advantage and low failure rate: Due to the use of advanced hydraulic systems and good methods, the operating failure rate can be reduced to a low level.

Try to use this equipment in areas with wind force less than level five, the door may not meet the above requirements, but safety should be maintained.

The end height of the guide rail frame above the high attachment point should comply with the provisions of the user manual.

Mechanical devices controlled by cage movement should not be used to open or close the landing door.

The wall bracket of the construction electric elevator should be intact and reliably fixed,BakersfieldWarehouse electric elevator, and its attachment distance, wall bracket spacing, and end height must comply with the requirements of the 'User Manual'. The angle between the plane of the wall bracket and the normal direction of the attachment surface should not exceed 8 degrees;. When the attachment device does not meet the requirements of the 'User Manual' due to conditions, its calculation sheet, design, and production materials should be confirmed by the manufacturer or reviewed by the technical leader of the installation unit, and verified by experts.

Superior quality.Setting requirements: The anti loosening and anti loosening parts between the connecting parts should comply with the provisions of the user manual and should not be replaced by other objects. For connecting bolts with pre tightening requirements, a torque wrench or special tool should be used to accurately tighten the bolts to the specified torque value according to the specified tightening sequence. When installing standard section connecting bolts, it is advisable to place the screw at the bottom and the nut at the top.

Afterwards, it should be scrapped.

Especially suitable for steel structured factories, suitable for both indoor and outdoor installation.

Bakersfield.Setting requirements: The guide rail should be rigid and flexible components such as wire ropes or chains should not be used.

Mechanical devices controlled by cage movement should not be used to open or close the landing door.

Safety performance: Electric elevators not only have the safety device of traditional traction elevators, but also have an overflow valve to prevent excessive system pressure during upward movement