BrusselsSimpleFor customers to use and operate the lifting platform for a long time, the editor briefly introduces how to maintain and repair the lifting platform: First of all, normal maintenance is mainly focused on prevention, resulting in costly repairs.
Setting requirements: When the distance between the outer edge of the construction electric elevator and the external overhead power line cannot meet the requirements of a small safety distance, the protective measures taken should comply with the specification requirements.
Brussels.Try to use this equipment in areas with wind force less than level five, and avoid using it when the wind force is too strong to avoid accidents.
There is no need to set up a computer room above the shaft like an elevator, and the top floor height can be installed at least 2.5 meters.
.Especially suitable for steel structured factories,BrusselsMobile electric elevator, otherwise protective measures shall be taken.
Protective measures should comply with regulatory requirements.
Setting requirements: Construction electric elevators should be equipped with a down travel (limit) switch. The down travel (limit) switch should be able to automatically stop the cage running at rated speed before reaching the lower limit switch.
High lifting height the side protection device for the landing entrance should be equipped.
The distance between the electric hoist and overhead line in Electrical safety construction shall meet the specification requirements, using side mounted oil cylinders, stable operation, noise free, easy maintenance, and longer service life.
Focus on Development.The end height of the guide rail frame above the high attachment point should comply with the provisions of the user manual.
Double layer steel mesh: The diameter of the steel bars is 12mm, with a spacing of 200mm.
In addition to ground protective fences, low level doors can be used. Low level doors should meet the following requirements: the height of the door should be between 1m and 2m. And there should be at least protective railings, a half height middle crossbar, and a toe board at least 150mm above the ground.
Braking. The brake limit switch for partial motion control of the electric hoist traction machine. Assembly that restricts the operation of the lift car when it is opened to a high or low position; If the limit switch controls the overtravel switch. When the car travels to a high or low position, it will take on the function of raising or lowering. In order to prevent the lift car from crashing or sinking, stage equipment should be dismantled with over travel switches that can cut off power and cannot be automatically reset, and installed in the machine room rather than in the shaft; A buffer should be installed that can absorb the energy of the moving mechanism and reduce impact.
Quality inspection report.Human improper operation is the main factor causing malfunctions in scissor type electric elevators. When stacking goods, electric elevators should stack the goods neatly, which is better than stacking them in the center of the cargo stacking area of the cargo elevator to avoid imbalance between the two ends of the stacking area. Eventually, during the operation of the electric elevator,BrusselsSimple electric hoist cargo elevator,BrusselsThree meter electric elevator, it may cause the electric elevator to lose balance. After the goods are stacked completely, ropes should be used to lock the goods, so that they are not afraid of the goods during the lifting process; Careless; Scattered down
The suspension cage movement can only be resumed after operator operation.
When the wall bracket cannot meet the requirements of the construction site, it should be designed and calculated separately.
Brussels.The safety notice board for construction electric elevators should be prominently placed on the hanging cage for the rated load capacity and rated number of passengers of the construction electric elevator. It is strictly prohibited to use construction electric elevators beyond the rated load capacity or rated number of passengers.
Drivers of construction electric elevators should hold special construction operations and are not allowed to operate without a certificate.
The safety notice board for construction electric elevators should be prominently placed on the hanging cage for the rated load capacity and rated number of passengers of the construction electric elevator. It is strictly prohibited to use construction electric elevators beyond the rated load capacity or rated number of passengers.