BielefeldFloor electric elevatorPrinciples and solutions of product problems

The end height of the guide rail frame above the high attachment point should comply with the provisions of the user manual.

During loading and unloading the horizontal distance between the edge of the cage door and the edge of the landing station should not exceed 50mm.

Bielefeld.Lower limit switch: In normal working state, before the suspension cage touches the buffer, the lower limit switch first acts.

Braking. The brake limit switch for partial motion control of the electric hoist traction machine. Assembly that restricts the operation of the lift car when it is opened to a high or low position; If the limit switch controls the overtravel switch. When the car travels to a high or low position, it will take on the function of raising or lowering. In order to prevent the lift car from crashing or sinking, stage equipment should be dismantled with over travel switches that can cut off power and cannot be automatically reset, and installed in the machine room, rather than in the shaft; A buffer should be installed that can absorb the energy of the moving mechanism and reduce impact.

.Horizontal lead screw mechanical electricity

Setting requirements: The installation and dismantling workers, and other operators of construction electric elevators should have special construction operations.

Especially suitable for steel structured factories, suitable for both indoor and outdoor installation.

Braking. The brake limit switch for partial motion control of the electric hoist traction machine. Assembly that restricts the operation of the lift car when it is opened to a high or low position; If the limit switch controls the overtravel switch. When the car travels to a high or low position, it will take on the function of raising or lowering. In order to prevent the lift car from crashing or sinking, stage equipment should be dismantled with over travel switches that can cut off power and cannot be automatically reset, and installed in the machine room, rather than in the shaft; A buffer should be installed that can absorb the energy of the moving mechanism and reduce impact.

In addition, when adding hydraulic oil, it is necessary to ensure the quality of the hydraulic oil, as some hydraulic oil manufacturers will choose hydraulic oil with poor quality. Hydraulic oil such as hydraulic lifting platforms not only cannot have any effect on folding arm elevators, but also affects the working efficiency of folding arm electric elevators due to deterioration issues.

Double layer steel mesh: The diameter of the steel bars is 12mm,BielefeldHand propelled electric elevator, with a spacing of 200mm.

Test method.Setting requirements: The anti loosening and anti loosening parts between the connecting parts should comply with the provisions of the user manual and should not be replaced by other objects. For connecting bolts with pre tightening requirements, a torque wrench or special tool should be used to accurately tighten the bolts to the specified torque value according to the specified tightening sequence. When installing standard section connecting bolts, it is advisable to place the screw at the bottom and the nut at the top.

Later, when there is a major malfunction of the lifting platform, it should be repaired by professional personnel as soon as possible. After the malfunction occurs,BielefeldMobile electric hydraulic elevator, it should not be used again to avoid accidents, it is driven by the pressure generated by its own weight, greatly saving energy and reducing consumption.

Lower limit switch: In normal working state, before the suspension cage touches the buffer, the lower limit switch first acts.

Setting requirements: When the distance between the outer edge of the construction electric elevator and the external overhead power line cannot meet the requirements of a small safety distance,BielefeldElectric elevator, the protective measures taken should comply with the specification requirements.

Bielefeld.The use of standard section connecting bolts should comply with the user manual and specification requirements.

Setting requirements: For construction electric elevators with foundations installed on roof slabs, floors, or other lower suspended structures, the bearing capacity of the foundation support structure should be checked. Click here to download the construction technical information for free. Basic drainage facilities should be installed.

Emergency manual valve: In case of power failure it can cause the car to descend to the nearest floor position and open the door