Bakersfield2 m
BakersfieldMicUse floor doors and cage door devices on construction sites where conditions permit.
The bearing capacity of the ground under the concrete foundation plate should be greater than 0.15Mpa.
Bakersfield.And prevent it from starting normally. There should be no device that allows users to cancel warning signals.
When the wall bracket adopts non matching standard products,BakersfieldSmall car electric elevator, design calculations should be carried out.
.The end height of the guide rail frame above the high attachment point should comply with the provisions of the user manual.
When applying a normal force of 300N to any position on either side of the door using a rigid 5000mm2 square or circular flat surface in the locked position of the landing door, it worked normally.
There is no need to set up a computer room above the shaft like an elevator, and the top floor height can be installed at least 2.5 meters.
Setting requirements: The verticality deviation of the installation of the guide rail frame of the construction electric elevator should comply with the requirements of the user manual and specifications, as specified in the above table.
Do not move after lifting, and do not lift until the four legs are firmly supported.
Principle of electric elevator rotary valve: When the electric elevator rises, the rotary valve will automatically open. To close the plug valve, it is necessary to first turn the handle to turn the plug to a 90 degree position until it is closed,BakersfieldSmall electric winch elevator, and then turn the transmission handwheel to lower the plug and achieve sealing.
Latest consultation.The oil cylinder and sealing components are made of imported components to solve the problem of unstable oil pressure and oil leakage of components for customers.
The spacing between wall brackets and the height of guide rails above the high attachment point should comply with the requirements of the user manual.
Installation and dismantling personnel and drivers should hold certificates to work.
Setting requirements: The guide rail should be rigid and flexible components such as wire ropes or chains should not be used.
index.The hydraulic oil forms a certain pressure by the vane pump, and enters the lower end of the hydraulic cylinder through an oil filter, throttle valve, hydraulic control one-way valve, and balance valve,Bakersfield3 meter high electric elevator, causing the hydraulic cylinder to move upwards and lift heavy objects. The return oil at the upper end of the hydraulic cylinder returns to the oil tank through the explosion-proof electromagnetic directional valve, and its rated pressure overflow valve is adjusted. The pressure gauge observes the reading value on the pressure gauge. The downward movement of the hydraulic cylinder (i.e. lowering of heavy objects).
And the decoration team is also using aluminum alloy electric elevators. What safety considerations should we consider during the use process? Many manufacturers have not clearly indicated it. Today, the mechanical editor will talk to you about aluminum alloys
Emergency manual valve: In case of power failure, it can cause the car to descend to the nearest floor position and open the door
Bakersfield.Double layer steel mesh: The diameter of the steel bars is 12mm, with a spacing of 200mm.
Every theater is a public place with a large number of people, and safety considerations should be taken into account in stage design. According to relevant national regulations, in order to prevent accidents caused by the crushing of electric elevators or improper control by drivers. Electric elevators should be equipped with the following necessary safety devices to ensure that the car of the electric elevator stops rising or falling in a timely manner.
The spacing between wall brackets and the height of guide rails above the high attachment point should comply with the requirements of the user manual.