HeimElectric pillar elevatorHow much do you know about the 11 characteristics of

Setting requirements: The spacing of wall brackets along the vertical direction should comply with the provisions of the user manual.

According to the needs of different performance genres, the form of the stage can be changed. For example,HeimElectric elevator platform, using an orchestra pit lift can combine a framed stage with a large lip or even an extended stage. In an experimental theater, using a lift can make the theater have various forms such as an end stage, an extended stage, an island stage, an intermediate stage, or a hall.

Heim.When a suspension cage with a rated load capacity acts on the buffer at a speed greater than the rated speed of 0.2m/s, the average deceleration of the suspension cage should not exceed 1g, and the time when the peak deceleration exceeds 5g should not exceed

Setting requirements: For construction electric elevators that operate in multiple shifts, the handover system should be implemented, and drivers should fill out the handover record form according to the standard requirements. The driver should conduct a pre shift inspection and confirm that there are no errors before starting the machine for operation.

.The verticality of the guide rail frame should meet the requirements of the specifications.

Safety grounding device. In order to protect against electrical equipment. The metal casing of electrical equipment and the metal structure of electric elevators should be equipped with a safety grounding device. The grounding wire should operate multiple wires, and the neutral wire should not be arbitrarily held as a safety grounding wire. Its grounding resistance should not exceed 4 ohms; The power supply of the electric elevator can be cut off.

Then, the lifting platform platform platform that carries the load needs to be balanced,HeimLight electric elevator, and no deviation of one side is allowed. The lifting of goods does not allow people to stand on both sides of the platform, and the lifting of goods should try to maintain a stable and uniform speed.

When the landing door is closed the full width of the lifting passage opening should be covered.

Precautions during operation: Mechanical operations should be gentle and smooth, and mechanical operations should be avoided, otherwise impact loads will inevitably occur, causing frequent mechanical failures and greatly shortening the service life. Generated during homework

Tank oil temperature protection: When the oil temperature in the tank exceeds the standard setting value, all equipped with imported high-quality pump stations, which can also be selected according to customer requirements to meet customer ideal requirements.

The landing door should meet the requirements of the specifications and achieve standardization.

The use of a lifting platform as a tool for storing performance blankets, soft scenery, etc. In some theaters, there is a soft scenery storage lifting platform located at an appropriate location on the stage for the storage of blankets soft scenery, etc.

Setting requirements: The main connection methods between the wall bracket and the building include: connecting the wall bracket with the embedded parts on the wall; Fix with wall bolts; Embedded bolts; Welding with steel structures.

Honesty and mutual benefit.Operating cost advantage and low failure rate: Due to the use of advanced hydraulic systems and good methods,HeimElectric pillar elevator, the operating failure rate can be reduced to a low level.

8m； When the lifting speed is greater than 0.8m/s, after the upper limit switch is triggered by the hanging cage, the upper small safety distance L should meet the following requirements: L=8+0.1V2, where L is the upper safety distance; V: Increase speed

Mechanical devices controlled by cage movement should not be used to open or close the landing door.

Heim.When a rigid 5000mm2 square or circular flat surface is applied with a normal force of 600N to either side of the door, the door may not meet the above requirements, but safety should be maintained.

The safety bulletin board for construction electric elevators should be hung at the protective shed of the electric elevator, with a size of 8 meters by 2 meters.

The angle between the wall bracket and the horizontal plane should comply with the requirements of the user manual.