Le HavreElectric mobile hydraulic elevatorHow to find the location

To meet the needs of choreographers and choreographers in different plays,Le HavreElectric folding elevator, different heights of the lifting platform can be used to change the shape of the stage according to the requirements of the choreographers and choreographers,Le HavreThree phase electric elevator, in order to adapt to the requirements of the plot for the scenery or venue, and save manpower and material resources for setting up. By using the tilting device of the lifting platform to form a tilted platform, special atmosphere and effects can be created. Even simple stage machinery often participates in performance activities, creating unexpected atmosphere and effects according to the needs of the plot. For example using the low-speed descent of the lifting platform to represent a sunken ship in the sea, using the valves on the lifting platform and the sudden disappearance and appearance of actors on the lifting platform.

Setting requirements: The spacing of wall brackets along the vertical direction should comply with the provisions of the user manual.

Le Havre.How to determine the sufficient amount of clean oil for the hydraulic station of an electric elevator? Why cannot water be used to flush the hydraulic station of an electric elevator?

Setting requirements: For construction electric elevators that operate in multiple shifts, the handover system should be implemented, strength testing report.

Mechanical devices controlled by cage movement should not be used to open or close the landing door.

Spiral electric lifting mechanism: With all the functions of a regular lifting platform, the main feature is that the equipment occupies a small foundation pit and has a large stroke. The equipment has a height of only 200-500mm and a travel distance of up to 14m. It is particularly suitable for buildings with stages built on two or more floors due to space constraints.

Construction electric elevators outside the lightning protection range

The isolation and buffering rubber in various parts of the aluminum alloy electric elevator drive device are intact and tightly fitted.

In addition to ground protective fences,Le HavreElectric tripod elevator, low level doors can be used. Low level doors should meet the following requirements: the height of the door should be between 1m and 2m. And there should be at least protective railings, a half height middle crossbar, and a toe board at least 150mm above the ground.

High value.During the use period, the user unit should organize professional technical personnel to inspect the construction electric elevator monthly according to the standard requirements, and record the inspection results.

The bearing capacity of the ground under the concrete foundation plate should be greater than 0.15Mpa.

The spacing between wall brackets and the height of guide rails above the high attachment point should comply with the requirements of the user manual.

The end height of the guide rail frame above the high attachment point should comply with the provisions of the user manual.

retailer.Protective measures should comply with regulatory requirements.

When adding hydraulic oil, it is also necessary to pay attention to the structure of the oil cylinder. Some oil cylinders are relatively complex internally, and how many lifting operations need to be carried out during filling to fully fill each position of the hydraulic oil. Therefore, when filling, try to add as much as possible, and then test and run the machine empty to see if it reaches the rated position.

The end height of the guide rail frame above the high attachment point should comply with the provisions of the user manual.

Le Havre.The setting of the cable guide frame should comply with the user manual and regulatory requirements.

The L distance depends on the selected wall mount model.

Setting requirements: The quality of the standard section should meet the requirements of the product manual. Before installing the construction electric elevator, all components should be inspected and standard sections and other components with severe wear and deformation should be replaced.