YuciElectric high-altitude elevatorIn a situation of oversupply

Small safe operation distance: Circuit voltage (kV) of external power lines<11~1035~110220330~550 Small safe operation distance (m) 4681015 Setting requirements: A small safe distance should be maintained between the outer edge of the construction electric elevator and the edge of the external overhead power line.

When the foundation is set on the roof or floor structure, the bearing capacity of its supporting structure should be checked.

Yuci.The noise of aluminum alloy electric elevators during operation is relatively low. If the noise is high, it is abnormal. Therefore, it is necessary to do a good job in troubleshooting, find the cause in a timely manner, reduce noise pollution, and reduce dangerous accidents

The counterweight guide rail should meet the specification requirements.

.Tank oil temperature protection: When the oil temperature in the tank exceeds the standard setting value, the oil temperature protection device sends a signal to suspend the use of the elevator. The elevator can only be started when the oil temperature drops

Flat screw mechanical electric lifting mechanism: The lifting platform of this structure has the advantages of small civil engineering coordination, shallow foundation pit required, large stroke, stable operation, low noise accurate positioning, and low cost. Adopting a horizontal screw drive and a scissor fork structure to achieve the lifting motion of the table, it can be stopped arbitrarily within the range of travel.

The setting of the cable guide frame should comply with the user manual and regulatory requirements.

Once again, weekly inspections should be conducted to check whether the connecting screws at various parts of the lifting platform are tightened, whether the sealing rings are damaged or ineffective, whether there is a lack of hydraulic oil, and whether the oil cylinder is leaking. It is necessary to clean the lifting frame,YuciElectric tricycle elevator, scissors, wiring, and oil cylinder once a week to avoid dust and debris affecting normal operation.

Lowering platform, vehicle mounted lifting platform, diesel engine curved arm self-propelled lifting platform,YuciElectric six meter elevator, folding arm lifting platform, cylinder sleeve lifting platform aluminum alloy lifting platform, and special

Mechanical devices controlled by cage movement should not be used to open or close the landing door.

Inspection basis.Setting requirements: The spacing of wall brackets along the vertical direction should comply with the provisions of the user manual.

Construction electric elevators should be equipped with cable guide frames and comply with regulatory requirements.

The angle between the wall bracket and the horizontal plane should comply with the requirements of the user manual.

The end height of the guide rail frame above the high attachment point should comply with the provisions of the user manual.

Home page recommendation.Setting requirements: Before starting work every day and changing shifts, the driver of the construction electric elevator should inspect the construction electric elevator according to the requirements of the user manual and specifications record the inspection results, and report any problems found to the user unit.

The body in the lateral adjustment device of the driving plate should ensure a compressed state, so that the gear has a certain radial constraint, the foundation should be inspected and accepted according to the requirements of the specifications. Only after passing the inspection can the installation be carried out.

Yuci.Braking. The brake limit switch for partial motion control of the electric hoist traction machine. Assembly that restricts the operation of the lift car when it is opened to a high or low position; If the limit switch controls the overtravel switch. When the car travels to a high or low position, it will take on the function of raising or lowering. In order to prevent the lift car from crashing or sinking, stage equipment should be dismantled with over travel switches that can cut off power and cannot be automatically reset, and installed in the machine room, the form of the stage can be changed. For example, using an orchestra pit lift can combine a framed stage with a large lip or even an extended stage. In an experimental theater, using a lift can make the theater have various forms such as an end stage,YuciElectric three wheel elevator, an extended stage, an island stage, an intermediate stage, a T-shaped stage, or a hall.