peitaihoTen meter electric elevatorWhat is it made of

The net height of the landing door opening should not be less than 8m, except for the gap between the lower part of the door that should not exceed 35mm, the size of any through-hole and opening related to the distance between any door and adjacent moving parts, as well as the gap around the door or between parts, should comply with the provisions of Table 4 of 'Mechanical Safety - Safety Distance to Prevent Upper and Lower Limbs from Touching Dangerous Areas' GB23821-2009.

Principle of electric elevator rotary valve: When the electric elevator rises, the rotary valve will automatically open. To close the plug valve,peitaihoSmall electric mobile elevator, it is necessary to first turn the handle to turn the plug to a 90 degree position until it is closed, and then turn the transmission handwheel to lower the plug and achieve sealing.

peitaiho.The down travel (limit) switch should be of the automatic reset type.

The safety notice board for construction electric elevators should be prominently placed on the hanging cage for the rated load capacity and rated number of passengers of the construction electric elevator. It is strictly prohibited to use construction electric elevators beyond the rated load capacity or rated number of passengers.

.Setting requirements: Before starting work every day and changing shifts, the driver of the construction electric elevator should inspect the construction electric elevator according to the requirements of the user manual and specifications, record the inspection results, and report any problems found to the user unit.

Setting requirements: The main connection methods between the wall bracket and the building include: connecting the wall bracket with the embedded parts on the wall; Fix with wall bolts; Embedded bolts; Welding with steel structures.

The connection method and angle between the wall bracket and the building structure should comply with the requirements of the user manual.

The use of standard section connecting bolts should comply with the user manual and specification requirements.

The down travel (limit) switch should be of the automatic reset type.

From the above comparison, it can be seen that hydraulic electric lifting mechanisms have stable lifting, low noise,peitaihoElectric tricycle elevator, long service life, large load bearing capacity, and are relatively simple, making them suitable for use in stage equipment.

Test results.Setting requirements: The quality of the standard section should meet the requirements of the product manual. Before installing the construction electric elevator, all components should be inspected, and standard sections and other components with severe wear and deformation should be replaced.

The wall bracket of the construction electric elevator should be intact and reliably fixed, and its attachment distance, wall bracket spacing, and end height must comply with the requirements of the 'User Manual'. The angle between the plane of the wall bracket and the normal direction of the attachment surface should not exceed 8 degrees;. When the attachment device does not meet the requirements of the 'User Manual' due to conditions, its calculation sheet, design, and production materials should be confirmed by the manufacturer or reviewed by the technical leader of the installation unit and verified by experts.

The scaffolding of the parking platform should be laid tightly and firmly.

Steel wire ropes, pulleys, and counterweight steel wire ropes shall comply with the following regulations: the characteristics of steel wire ropes shall comply with the requirements of General Purpose Steel Wire Ropes GB/T20118; Maintenance, and corrosion of steel wire ropes

Encyclopedic knowledge.Speed limit wire rope switch. When the speed limit wire rope trips or breaks. Make the electric elevator unable to start.

And prevent it from starting normally. There should be no device that allows users to cancel warning signals.

Setting requirements: Drainage measures should be set up for the foundation of construction electric elevators to ensure smooth drainage.

peitaiho.Acceptance: Concrete strength grade C30 deformation, strength testing report.

The wall bracket of the construction electric elevator should be intact and reliably fixed, and its attachment distance, wall bracket spacing, and end height must comply with the requirements of the 'User Manual'. The angle between the plane of the wall bracket and the normal direction of the attachment surface should not exceed 8 degrees;. When the attachment device does not meet the requirements of the 'User Manual' due to conditions, its calculation sheet, design, and production materials should be confirmed by the manufacturer or reviewed by the technical leader of the installation unit, and verified by experts.

Setting requirements: Drainage measures should be set up for the foundation of construction electric elevators to ensure smooth drainage.