ToulonElectric elevators for construction sitesReveal how to keep it safe

Setting requirements: The installation and dismantling workers, electricians, and other operators of construction electric elevators should have special construction operations.

The list of materials for making landing doors is as follows: Table 1: List of materials for making landing doors. Landing doors should be installed at the entrance of each landing station, and the landing doors should function properly.

Toulon.Only after the operation of professional personnel can the suspension cage movement be restored.

As a material loading and unloading equipment recognized by customers in the lifting platform, the guide rail hydraulic lifting platform is superior in terms of product, civil engineering,ToulonElectric hydraulic elevator platform, and operating costs. The editor of the electric elevator will provide a detailed analysis: the advantages of the product are that the equipment bears a large load, and can be controlled up and down floors to achieve safe use.

.Drivers of construction electric elevators should hold special construction operations and are not allowed to operate without a certificate.

Emergency manual valve: In case of power failure, it can cause the car to descend to the nearest floor position and open the door

From the perspective of the safety performance of the machinery itself,ToulonFully automatic electric elevator, those that have undergone national safety certification will not have significant safety issues. The main problem is that after using the electric elevator for a period of time, mechanical components may fall off or be damaged due to various factors. This problem depends on regular inspection and maintenance of the machinery

Pipeline rupture valve: When the hydraulic system pipeline ruptures and the car stalls and descends, it can automatically cut off the oil circuit and stop descent

And prevent it from starting normally. There should be no device that allows users to cancel warning signals.

Flat screw mechanical electric lifting mechanism: The lifting platform of this structure has the advantages of small civil engineering coordination, shallow foundation pit required, large stroke, low noise, accurate positioning, and low cost. Adopting a horizontal screw drive and a scissor fork structure to achieve the lifting motion of the table, it can be stopped arbitrarily within the range of travel.

production costs.When the landing door is closed,ToulonElectric fork lift table, the full width of the lifting passage opening should be covered.

In addition to ground protective fences, low level doors can be used. Low level doors should meet the following requirements: the height of the door should be between 1m and 2m. And there should be at least protective railings, a half height middle crossbar, and a toe board at least 150mm above the ground.

Drivers of construction electric elevators should hold special construction operations and are not allowed to operate without a certificate.

Double layer steel mesh: The diameter of the steel bars is 12mm, with a spacing of 200mm.

The cheapest.The oil cylinder and sealing components are made of imported components to solve the problem of unstable oil pressure and oil leakage of components for customers.

Do not move after lifting, and do not lift until the four legs are firmly supported.

Braking. The brake limit switch for partial motion control of the electric hoist traction machine. Assembly that restricts the operation of the lift car when it is opened to a high or low position; If the limit switch controls the overtravel switch. When the car travels to a high or low position, it will take on the function of raising or lowering. In order to prevent the lift car from crashing or sinking, stage equipment should be dismantled with over travel switches that can cut off power and cannot be automatically reset, and installed in the machine room, rather than in the shaft; A buffer should be installed that can absorb the energy of the moving mechanism and reduce impact.

Toulon.Double layer steel mesh: The diameter of the steel bars is 12mm, with a spacing of 200mm.

The function of the lifting platform in a theater is roughly as follows: the main lifting platform arranged in the main performance area of the stage is mainly used to quickly change the scenery. Typically, with&quo; Product; In the music and dance theater stage arranged in a zigzag pattern the lifting platform, side car platform and rear car turntable perform a rapid transformation of the entire or partial scene. This arrangement allows for rapid switching of three full sets.

Emergency manual valve: In case of power failure, it can cause the car to descend to the nearest floor position and open the door