SwatpskFully electric high-altitude reclaimerWhat caused the burning-World information network

Passengers wearing long skirts and strapping sandals when riding on the escalator should try to stand slightly in the middle of the escalator to prevent shoes and clothing from being drawn into the escalator and causing danger, and to prevent skirts or pants from getting stuck.

When passengers are riding on the escalator, they may lose their balance and fall due to leaning against the skirt board on the side of the escalator, which does not move, but their feet move with the steps. Especially when carrying a lot of packages while taking the elevator, it is more likely to fall on the escalator due to the inability to hold the handrail properly. So, when riding on the escalator, we must stand firmly and support it well and do not lean against the skirt board on the side of the escalator.

Swatpsk.b. When the old elevator cannot start: due to the inability to enter the shaft, the plane size of the shaft can be measured in the machine room limited data can only be obtained from outside the shaft to determine whether it is non-standard (if there is a high platform in the machine room, but it is not accurate enough) for elevator quotation negotiation reference. In this case, the signing of the contract should state that the shaft rectification and costs are the responsibility of the user. For uncertain shaft structures and dimensions, users should be reminded to provide them to the elevator after the old elevator or notify the elevator to take measurements before the new elevator is put into operation.

2. Different types of civil engineering traction elevators, screw elevators, and hydraulic elevators have different requirements for civil engineering. Common traction elevators require a certain amount of hoistway space, which can be made of concrete, steel structure hoistways, and glass curtain walls to create sightseeing elevators; The depth of the pit should be at least 50cm or more; Additionally, it will lose control and engage in falling movements.

In the event of a fire, when instructed by the fire center or the dedicated operation button of the first floor firefighter to enter the firefighting state, the elevator should immediately stop at the floor without opening the door, and then return to the first floor station and automatically open the elevator door.

Sampling inspection.When encountering abnormal elevator operation, you can call the repair hotline to consult with the maintenance personnel or inform the service center to handle it. Do not take unauthorized measures to avoid causing greater harm to the elevator or even causing casualties.

The braking system of the elevator is usually closed, which means it is in the braking state when there is no power, and only when it needs to be turned on, the brakes closed and the elevator was braked in mid air. When the elevator descends abnormally, it is cut off

The seat elevator person sits on a chair driven by an electric motor, and the button on the chair handle causes the power drive device at the bottom of the chair to drive the person chair up and down along the guide rail of the staircase railing

SwatpskFully electric high-altitude reclaimerWhat caused the burning

Elevators are used to transport firefighters, passengers,SwatpskStage hydraulic lifting platform, and fire-fighting equipment in the event of a fire. They are used to transport frozen goods in large cold storage or refrigeration workshops. However, they need to meet the requirements of sealing the door leaves and guide rails at the moving parts. Professional household elevators, villa household elevators, household elevator manufacturers, and small household elevators have stable, safe, reliable, and maintenance free performance, and their technical level has reached the domestic level, Meet the advanced level of international similar products and immersion requirements

original.Aircraft weighing tens or hundreds of tons in the elevator hangar are vertically lifted onto the airport runway

Reduce the overall noise of the machine. Due to the absence of noise from bearings during high-speed operation of an asynchronous motor and the absence of noise from worm gear transmission, the overall noise can be reduced by 5-10db (A) Low energy consumption. From the working principle of permanent magnet synchronous motors, it can be seen that their excitation is achieved by permanent magnets, and there is no need for the stator to provide additional excitation current. Therefore, the rotor of the motor has no current and there is no problem of electronic loss. Generally, it reduces consumption by 45% -60% compared to asynchronous motors. Due to the lack of low efficiency and high energy consumption worm gear transmission pairs, energy consumption is further reduced.

Swatpsk.The elevator suddenly opens the door and does not move after leveling, but automatically resumes operation after a few minutes: The elevator (escalator) has been running for too long, and the motor overheats. To prevent burning out, the motor cools down and automatically resumes operation.

When passengers are riding on the escalator, they may lose their balance and fall due to leaning against the skirt board on the side of the escalator which does not move, but their feet move with the steps. Especially when carrying a lot of packages while taking the elevator,SwatpskHousehold sightseeing elevator,SwatpskFlip plate hydraulic roadblock machine, it is more likely to fall on the escalator due to the inability to hold the handrail properly. So when riding on the escalator, we must stand firmly and support it well, and do not lean against the skirt board on the side of the escalator.

If there is a reserved shaft in the villa residential area, the appropriate car model can be selected by comparing the width and depth of the elevator car based on the size, width, you can first choose the model of the elevator and create a new shaft based on the required reserved size space for different models.