peitaihoCost o
peitaihoVilla Overloaded elevators do not operate: The load of elevators is limited, and if they are overweight, they will alarm and generally cannot be started. Most passengers can also voluntarily exit.
When wearing high heels, be careful not to step on the gap between the pedals, as not wearing shoes is more likely to be pinched by the toothed plate.
peitaiho.The compensation chain and rope shall not collide with the shaft or other components during the operation of the elevator.
Elevator does not close the door or repeatedly opens and closes the door: there are debris blocking the light curtain or door contact plate at the entrance or sill.
.The seat elevator person sits on a chair driven by an electric motor, be careful not to step on the gap between the pedals, as not wearing shoes is more likely to be pinched by the toothed plate.
Aircraft weighing tens or hundreds of tons in the elevator hangar are vertically lifted onto the airport runway
The elevator suddenly opens the door and does not move after leveling, but automatically resumes operation after a few minutes: The elevator (escalator) has been running for too long, and the motor overheats. To prevent burning out,peitaihoSmall stage elevator, the motor cools down and automatically resumes operation.
The progressiveness of elevator is mainly reflected in the drive and technology. The frequency modulation voltage regulation speed regulation technology (VVVF) is now the main energy-saving and drive technology. The microcomputer system realizes intelligence for elevators, with low failure rate, high reliability, which means it is in the braking state when there is no power, and only when it needs to be turned on, will the power turn on the brakes. So as soon as there was a power outage, the brakes closed and the elevator was braked in mid air. When the elevator descends abnormally, it is cut off
Inspection environment.Aircraft weighing tens or hundreds of tons in the elevator hangar are vertically lifted onto the airport runway
The elevator suddenly descends to the bottom floor and resumes normal operation: After the elevator is powered off and reconnected, the leveling reference position needs to be re determined.
When passengers are riding on the escalator, they may lose their balance and fall due to leaning against the skirt board on the side of the escalator, which does not move, it is more likely to fall on the escalator due to the inability to hold the handrail properly. So, when riding on the escalator, we must stand firmly and support it well,peitaihoRear flip hydraulic flipper, and do not lean against the skirt board on the side of the escalator.
Elevator does not close the door or repeatedly opens and closes the door: there are debris blocking the light curtain or door contact plate at the entrance or sill.
management.When wearing high heels, be careful not to step on the gap between the pedals, as not wearing shoes is more likely to be pinched by the toothed plate.
Technical performance that needs to be emphasized& mdash; Reliability, progressiveness and comfort The so-called reliability refers to the ability of the elevator system to maintain the specified function within the specified time. Our requirement for elevator reliability is to minimize malfunctions during operation time and make it easy to eliminate them once they occur. This requires us to choose products with high reliability, such as professional home elevators, villa home elevators, home elevator manufacturers, and small home elevators, which have a complete range of products and are popular both domestically and internationally. Our equipment has a long service life! The product wire product industry is leading, welcome to inquire. The elevator configuration is good, and fortunately,peitaihoVilla Home Seat Elevator, there is a dedicated maintenance team in the local area.
When wearing high heels, be careful not to step on the gap between the pedals as not wearing shoes is more likely to be pinched by the toothed plate.
peitaiho.Elevator Tip 1: Why elevators can trap people? Every elevator door on each floor has a safety switch, which can trigger the elevator to shut down in case of any abnormality. The elevator getting stuck is actually when the system detects an abnormal signal and triggers a protective device, like braking to stop.
The elevator stops on the first floor and the door does not move: the fire emergency landing function of the elevator is triggered by smoke or thermal sensors inside the building.
Will the elevator quickly fall during a power outage& mdash;& mdash; Some movies and TV dramas often mislead the public into thinking that if the elevator loses its power it will lose control and engage in falling movements.