Riverside SeineRotating lifting stageToday's price

announcer:hp938HP166090698 release time:2024-07-30 13:39:52

Riverside SeineGrain hydraulic flipper,

When accidentally trapped in an elevator, one should remain calm, press the alarm bell inside the elevator, and call the elevator emergency rescue phone or community property phone for help. Do not open doors or mess with buttons, and patiently wait for rescue.

The seat elevator person sits on a chair driven by an electric motor, and the button on the chair handle causes the power drive device at the bottom of the chair to drive the person chair up and down along the guide rail of the staircase railing

Riverside Seine.The household must make two steel splints above the entrance. The position and size of the clamp plate are determined based on the selected door machine model.

The elevator stops on a certain floor for a long time without moving or responding to external calls: it is possible that the elevator administrator has activated the driver operation function.

.If there is a reserved shaft in the villa residential area, width, and depth of the shaft. If there is no reserved shaft you can first choose the model of the elevator and create a new shaft based on the required reserved size space for different models.

The elevator suddenly descends to the bottom floor and resumes normal operation: After the elevator is powered off and reconnected, the leveling reference position needs to be re determined.

The elevator suddenly opens the door and does not move after leveling, but automatically resumes operation after a few minutes: The elevator (escalator) has been running for too long, and the motor overheats. To prevent burning out, the motor cools down and automatically resumes operation.


Riverside SeineRotating lifting stageToday



The gantry elevator is used in the door legs of large gantry cranes to transport workers and maintenance components inside the gantry crane

The compensation chain and rope shall not collide with the shaft or other components during the operation of the elevator.

When passengers are riding on the escalator, they may lose their balance and fall due to leaning against the skirt board on the side of the escalator, which does not move, but their feet move with the steps. Especially when carrying a lot of packages while taking the elevator, it is more likely to fall on the escalator due to the inability to hold the handrail properly. So, when riding on the escalator, we must stand firmly and support it well, and do not lean against the skirt board on the side of the escalator.

average method.When accidentally trapped in an elevator one should remain calm, press the alarm bell inside the elevator, and call the elevator emergency rescue phone or community property phone for help. Do not open doors or mess with buttons, and to prevent skirts or pants from getting stuck.

When wearing high heels, be careful not to step on the gap between the pedals, as not wearing shoes is more likely to be pinched by the toothed plate.


Riverside SeineRotating lifting stageToday



These phenomena are not elevator malfunctions. When the elevator is fully loaded, the elevator does not stop: to avoid overloading, the elevator car no longer responds to the next station's outbound call.

Information recommendation.When wearing high heels, be careful not to step on the gap between the pedals, as not wearing shoes is more likely to be pinched by the toothed plate.

The effective support width of the upper and lower support beams should be greater than the width of the escalator truss, and there should be embedded steel plates.

Aircraft weighing tens or hundreds of tons in the elevator hangar are vertically lifted onto the airport runway

Riverside Seine.Household elevators must be regularly maintained to confirm their safety and whether they can continue to operate, while also repairing any faults and hidden dangers found.

There are many similar situations in daily life, such as forcefully opening the door inside the car, causing the circuit to disconnect and forcing the elevator to stop, resulting in people being trapped. For example, if the elevator frequently enters and exits during decoration and falls into the crack of the door, the elevator hall door may not be tightly closed, and after several consecutive doors are opened and closed, and new and old customers are welcome to come for consultation

Elevator does not close the door or repeatedly opens and closes the door: there are debris blocking the light curtain or door contact plate at the entrance or sill.