Overloaded elevators do not operate: The load of elevators is limited, and if they are overweight, they will alarm and generally cannot be started. Most passengers can also voluntarily exit.
The elevator stops on the first floor and the door does not move: the fire emergency landing function of the elevator is triggered by smoke or thermal sensors inside the building.
Teney.Reduce the overall noise of the machine. Due to the absence of noise from bearings during high-speed operation of an asynchronous motor and the absence of noise from worm gear transmission, the overall noise can be reduced by 5-10db (A) Low energy consumption. From the working principle of permanent magnet synchronous motors, it can be seen that their excitation is achieved by permanent magnets,TeneyHousehold outdoor elevator on the third floor, and there is no need for the stator to provide additional excitation current. Therefore, the power factor of elevators can reach a very high level. At the same time, the rotor of the motor has no current and there is no problem of electronic loss. Generally, it reduces consumption by 45% -60% compared to asynchronous motors. Due to the lack of low efficiency and high energy consumption worm gear transmission pairs, energy consumption is further reduced.
Elevators are used to transport firefighters,TeneySmall stage elevator, passengers, and fire-fighting equipment in the event of a fire. They are used to transport frozen goods in large cold storage or refrigeration workshops. However, they need to meet the requirements of sealing the door leaves and guide rails at the moving parts. Professional household elevators, villa household elevators, household elevator manufacturers and small household elevators have stable, reliable and maintenance free performance, Meet the advanced level of international similar products and immersion requirements
.These phenomena are not elevator malfunctions. When the elevator is fully loaded and their technical level has reached the domestic level, the elevator does not stop: to avoid overloading, the elevator car no longer responds to the next station's outbound call.
Elevator Tip 1: Why elevators can trap people? Every elevator door on each floor has a safety switch, which can trigger the elevator to shut down in case of any abnormality. The elevator getting stuck is actually when the system detects an abnormal signal and triggers a protective device, like braking to stop.
If there is a reserved shaft in the villa residential area, the appropriate car model can be selected by comparing the width and depth of the elevator car based on the size, width, and depth of the shaft. If there is no reserved shaft, you can first choose the model of the elevator and create a new shaft based on the required reserved size space for different models.
When encountering abnormal elevator operation, you can call the repair hotline to consult with the maintenance personnel or inform the service center to handle it. Do not take unauthorized measures to avoid causing greater harm to the elevator or even causing casualties.
The progressiveness of elevator is mainly reflected in the drive and technology. The frequency modulation voltage regulation speed regulation technology (VVVF) is now the main energy-saving and drive technology. The microcomputer system realizes intelligence for elevators, high reliability, and strong anti-interference ability in use.
When accidentally trapped in an elevator, one should remain calm, press the alarm bell inside the elevator, and call the elevator emergency rescue phone or community property phone for help. Do not open doors or mess with buttons, and patiently wait for rescue.
Excellent quality.Aircraft weighing tens or hundreds of tons in the elevator hangar are vertically lifted onto the airport runway
Mine elevators are used for transporting personnel and goods in mines. Special elevators are designed for special environmental conditions, such as explosion-proof,TeneySelf propelled aluminum alloy elevator, anti-corrosion, and heat-resistant elevators
Overloaded elevators do not operate: The load of elevators is limited, they will alarm and generally cannot be started. Most passengers can also voluntarily exit.
Overloaded elevators do not operate: The load of elevators is limited, and if they are overweight, they will alarm and generally cannot be started. Most passengers can also voluntarily exit.
Installation requirements.Home elevators are different from special products such as public spaces, professional home elevators, villa home elevators, home elevator manufacturers, and small home elevators. They are 20 year old brands with advantages in price and guaranteed quality. Considering the limited installation space, lack of dedicated hoistways, and small lifting height, they pursue simplicity and miniaturization in design, and the existence of computer rooms is not necessary. Long term promotion of a domestic elevator manufacturer, a 20 year old brand with competitive prices and guaranteed quality!
Multiple elevator shafts can be connected and an 18-20 # I-beam can be fixed at a certain height between each adjacent elevator shaft, with the same position as the ring beam. The pit must be equipped with an isolation net that is 2500mm above the ground level.
The elevator stops on a certain floor for a long time without moving or responding to external calls: it is possible that the elevator administrator has activated the driver operation function.
Teney.In daily life, elevators are a commonly used tool that brings us a lot of convenience. But how much do you know about the types and safety knowledge of elevators?
When encountering abnormal elevator operation, you can call the repair hotline to consult with the maintenance personnel or inform the service center to handle it. Do not take unauthorized measures to avoid causing greater harm to the elevator or even causing casualties.
Elevator does not close the door or repeatedly opens and closes the door: there are debris blocking the light curtain or door contact plate at the entrance or sill.