XinhuaElectric
XinhuaMobile e
AustinSmall moThere is no need to set up a computer room above the shaft like an elevator,XinhuaElevator electric elevator, and the top floor height can be installed at least 2.5 meters.
Installation and dismantling personnel and drivers should hold certificates to work.
Xinhua.Try to use this equipment in areas with wind force less than level five and avoid using it when the wind force is too strong to avoid accidents.
The distance between the electric hoist and overhead line in Electrical safety construction shall meet the specification requirements, otherwise protective measures shall be taken.
.The L distance depends on the selected wall mount model.
The foundation production and acceptance of electric elevators for foundation construction should comply with the user manual and regulatory requirements.
The distance between the electric hoist and overhead line in Electrical safety construction shall meet the specification requirements, otherwise protective measures shall be taken.
Safety performance: Electric elevators not only have the safety device of traditional traction elevators, but also have an overflow valve to prevent excessive system pressure during upward movement
Check whether the sealing of components such as the oil cylinder, and motor of the aluminum alloy electric elevator is good and whether there is any air leakage.
When the landing door is closed, the full width of the lifting passage opening should be covered.
retailer.Tank oil temperature protection: When the oil temperature in the tank exceeds the standard setting value, the oil temperature protection device sends a signal to suspend the use of the elevator. The elevator can only be started when the oil temperature drops
The bearing capacity of the ground under the concrete foundation plate should be greater than 0.15Mpa.
During loading and unloading,XinhuaElectric light lift,XinhuaPortable electric elevator, it can ensure that the equipment does not tilt during operation. Gear and rack electric lifting mechanism: precise transmission and high cost.
Installation material list.The foundation base or embedded parts should be fully embedded in the concrete foundation plate.
Installation position of upper limit switch: Under normal working conditions, the distance between the upper limit switch and the upper limit switch is 0.15m for SC type construction electric elevators, and 0.15m for SS type construction electric elevators (person)
Spiral electric lifting mechanism: With all the functions of a regular lifting platform, the main feature is that the equipment occupies a small foundation pit and has a large stroke. The equipment has a height of only 200-500mm and a travel distance of up to 14m. It is particularly suitable for buildings with stages built on two or more floors due to space constraints.
Xinhua.Buffer. In order to increase the energy for the car to hit the top or sink to the bottom. Remove rubber or sponge from the buffer and cabin to increase their impact energy; Rope groove slipping and other accidents caused the car to suddenly fall resulting in a safety clamp. To prevent breakage of the lifting wire rope. A safety clamp that can simultaneously cut off the power supply and stop the car from falling should be removed from the car. A car without safety tongs is not allowed to ride or carry people. If it is a simple electric elevator, there should be a safety device (such as a safety stop pin) to prevent people from suddenly falling when loading and unloading goods in the car; Electric elevators with three or more floors (including three floors) for passengers or passengers.
Emergency manual valve: In case of power failure, it can cause the car to descend to the nearest floor position and open the door
As a material loading and unloading equipment recognized by customers in the lifting platform, the guide rail hydraulic lifting platform is superior in terms of product, civil engineering, and operating costs. The editor of the electric elevator will provide a detailed analysis: the advantages of the product are that the equipment bears a large load, can achieve multiple points, and can be controlled up and down floors to achieve safe use.