HandanElectric
HandanElectricHandanElectric tripod elevator,HandanCurved arm electric elevator,
During normal operation, the horizontal distance between the closed cage door and the closed landing door should not exceed 150mm. Otherwise, measures should be taken to make it meet the requirements, and avoid using it when the wind force is too strong to avoid accidents.
Especially suitable for steel structured factories, suitable for both indoor and outdoor installation.
.The motor of the hydraulic guide rail lifting platform is set around the wellbore,Handan4 meter high electric elevator, occupying a relatively small area, improving the utilization rate of the wellbore area.
Safety grounding device. In order to protect against electrical equipment. The metal casing of electrical equipment and the metal structure of electric elevators should be equipped with a safety grounding device. The grounding wire should operate multiple wires, and the neutral wire should not be arbitrarily held as a safety grounding wire. Its grounding resistance should not exceed 4 ohms; The power supply of the electric elevator can be cut off.
Especially suitable for steel structured factories, suitable for both indoor and outdoor installation.
The spacing between wall brackets and the height of guide rails above the high attachment point should comply with the requirements of the user manual.
Setting requirements: Steel wire rope electric elevators and reusable steel wire ropes should be equipped with anti loosening rope devices, which should have compliant loosening rope switches and be able to interrupt any movement of the cage until it passes through the
Acceptance: Concrete strength grade C30, strength testing report.
market.When the distance between the outer edge of the construction electric elevator and the edge line of the external overhead power line cannot meet the requirements in the table above, effective protective measures should be taken.
The entrance of each landing platform must be equipped with a landing door, which must open towards the landing platform side, and the door bolt must be set on the side next to the construction electric elevator.
Setting requirements: The wall bracket should use the manufacturer's matching standard products.
Setting requirements: The foundation and foundation of the construction electric elevator should meet the requirements of the user manual. Before installing the construction electric elevator, the foundation should be inspected and accepted according to the requirements of the specifications. Only after passing the inspection can the installation be carried out.
Word of mouth recommendation.The verticality of the guide rail frame should meet the requirements of the specifications.
During maintenance or when problems occur, the power supply should be cut off in a timely manner. After lifting, the aluminum alloy electric elevator should be firmly fixed before maintenance can be carried out. It is strictly prohibited to operate with defects to avoid accidents.
The oil cylinder and sealing components are made of imported components to solve the problem of unstable oil pressure and oil leakage of components for customers.
Handan.When a rigid 5000mm2 square or circular flat surface is applied with a normal force of 600N to either side of the door, but safety should be maintained.
Especially suitable for steel structured factories, suitable for both indoor and outdoor installation.
The bearing capacity of the ground under the concrete foundation plate should be greater than 0.15Mpa.