Xinjiang15 met
XinjiangElectrWhen the wall bracket cannot meet the requirements of the construction site, it should be designed and calculated separately.
There is no need to set up a computer room above the shaft like an elevator, and the top floor height can be installed at least 2.5 meters.
Xinjiang.Check the starter potential when the lifting table is not raised or the voltage is too low when the motor load is working. Voltage hydraulic range allowed&
Pipeline rupture valve: When the hydraulic system pipeline ruptures and the car stalls and descends, it can automatically cut off the oil circuit and stop descent
.Setting requirements: Each landing entrance should be equipped with a landing door, which should cover the opening with its full width,XinjiangElectric basket elevator, and should not open towards the lifting passage.
Horizontal lead screw mechanical electricity
Setting requirements: The guide rail should be rigid and flexible components such as wire ropes or chains should not be used.
The safety bulletin board for construction electric elevators should be hung at the protective shed of the electric elevator, with a size of 8 meters by 2 meters.
The shutdown device (emergency stop switch) should be non automatic reset type.
The oil cylinder and sealing components are made of imported components to solve the problem of unstable oil pressure and oil leakage of components for customers.
Honesty and mutual benefit.Drainage measures need to be considered around the foundation. (Drain the accumulated water on the foundation).
Especially suitable for steel structured factories, suitable for both indoor and outdoor installation.
Operating cost advantage and low failure rate: Due to the use of advanced hydraulic systems and good methods,XinjiangElectric elevator, the operating failure rate can be reduced to a low level.
Use floor doors and cage door devices on construction sites where conditions permit.
manufacturer.Secondly, for the replacement of hydraulic oil on the lifting platform, it is recommended to replace it every three months. If the frequency of use is not high it can be replaced once a year. The hydraulic oil must be clean, and after changing the hydraulic oil, it must be automatically lifted and lowered 2 to 3 times to ensure that the air in the oil cylinder is completely discharged, maintain sufficient space, it is necessary to charge it in a timely manner. When the equipment is used for about 2 months (according to the actual frequency of use), it is necessary to add grease to the rotating parts once; Regularly inspect the working status of the pin shaft of the fully self-propelled electric elevator every month, and if any pin shaft is found
Emergency manual valve: In case of power failure, it can cause the car to descend to the nearest floor position and open the door
Xinjiang.Setting requirements: For construction electric elevators that operate in multiple shifts,Xinjiang4 meter high electric elevator, the handover system should be implemented, and drivers should fill out the handover record form according to the standard requirements. The driver should conduct a pre shift inspection and confirm that there are no errors before starting the machine for operation.
The landing door should be in a normally closed state. Without the permission of the construction electric elevator driver, the landing door shall not be opened.
Human improper operation is the main factor causing malfunctions in scissor type electric elevators. When stacking goods, electric elevators should stack the goods neatly which is better than stacking them in the center of the cargo stacking area of the cargo elevator to avoid imbalance between the two ends of the stacking area. Eventually, during the operation of the electric elevator, it may cause the electric elevator to lose balance. After the goods are stacked completely, so that they are not afraid of the goods during the lifting process; Careless; Scattered down