GilbertScissor fork electric elevatorGood service

Setting requirements: The guide rail should be rigid and flexible components such as wire ropes or chains should not be used.

The distance between the electric hoist and overhead line in Electrical safety construction shall meet the specification requirements, otherwise protective measures shall be taken.

Gilbert.Before each shift of work, the safety devices of the construction electric elevator should be inspected to ensure sensitivity and reliability.

The full height landing door should meet the following requirements: the net height of the landing door opening should not be less than 0m. In special circumstances when the net height of the building entrance is less than 0m, it is allowed to lower the height of the lower door opening, but in any case, the net height of the lower door opening is not less than 8m. (Article 1 of GB26557-2011)

.Once again, weekly inspections should be conducted to check whether the connecting screws at various parts of the lifting platform are tightened, whether the sealing rings are damaged or ineffective, whether there is a lack of hydraulic oil, and whether the oil cylinder is leaking. It is necessary to clean the lifting frame, scissors, wiring,GilbertElectric chain elevator, and oil cylinder once a week to avoid dust and debris affecting normal operation.

Implementing multiple shifts of homework should fill in and submit records according to regulations.

In addition to ground protective fences, low level doors can be used. Low level doors should meet the following requirements: the height of the door should be between 1m and 2m. And there should be at least protective railings, a half height middle crossbar, and the top layer is not affected. It can be customized according to the location and environment.

Steel wire rope construction electric elevators and reusable steel wire ropes should be equipped with anti loosening rope devices, which should have compliant loosening rope switches and be able to interrupt any movement of the lifting cage until it is approved by a professional

Manual pump: When the system malfunctions, the manual pump can be operated to pump high-pressure oil to raise the car to the nearest floor position

Quality department.News Abstract: The development of the lifting platform industry will continue to grow in recent years! With the continuous development of electric lifting machinery for high-altitude operations in recent years, the products of electric lifting platform vehicles have been continuously improved, making the further development of lifting platform vehicles possible.

The list of materials for making landing doors is as follows: Table 1: List of materials for making landing doors. Landing doors should be installed at the entrance of each landing station and the landing doors should function properly.

Implementing multiple shifts of homework should fill in and submit records according to regulations.

Steel wire ropes, pulleys, and counterweight steel wire ropes shall comply with the following regulations: the characteristics of steel wire ropes shall comply with the requirements of General Purpose Steel Wire Ropes GB/T20118; Maintenance,GilbertElectric simple elevator, wear, deformation, and corrosion of steel wire ropes

Recommendation and consultation.Setting requirements: Drainage measures should be set up for the foundation of construction electric elevators to ensure smooth drainage.

When adding hydraulic oil, we can extend the oil cylinder to the high position for filling. When filling, the lifting platform should not exceed the high position, and then retract the oil cylinder back to the low position to check if the hydraulic oil level is lower than the low position, and maintain it between the two.

Safety performance: Electric elevators not only have the safety device of traditional traction elevators, but also have an overflow valve to prevent excessive system pressure during upward movement

Gilbert.Drivers of construction electric elevators should hold special construction operations and are not allowed to operate without a certificate.

The quality of the standard section should comply with the product manual and specification requirements.

The connection method and angle between the wall bracket and the building structure should comply with the requirements of the user manual.