Saint DenisNiu
Saint NazaireEThe spacing between wall brackets and the height of guide rails above the high attachment point should comply with the requirements of the user manual.
In addition to ground protective fences low level doors can be used. Low level doors should meet the following requirements: the height of the door should be between 1m and 2m. And there should be at least protective railings, and a toe board at least 150mm above the ground.
Saint Etienne.The isolation and buffering rubber in various parts of the aluminum alloy electric elevator drive device are intact and tightly fitted.
The advantages and disadvantages of several commonly used electric lifting mechanisms are as follows: hydraulic electric lifting mechanisms: using hydraulic technology,Saint EtienneFully electric self-propelled elevator, smooth lifting and low noise.
.Setting requirements: The spacing of wall brackets along the vertical direction should comply with the provisions of the user manual.
Secondly,Saint EtienneWarehouse electric elevator, for the replacement of hydraulic oil on the lifting platform, it is recommended to replace it every three months. If the frequency of use is not high, it can be replaced once a year. The hydraulic oil must be clean, it must be automatically lifted and lowered 2 to 3 times to ensure that the air in the oil cylinder is completely discharged, maintain sufficient space, and ensure that the lifting platform can be lifted to the rated lifting height.
Double layer steel mesh: The diameter of the steel bars is 12mm, with a spacing of 200mm.
The wall bracket of the construction electric elevator should be intact and reliably fixed, and its attachment distance, wall bracket spacing, and end height must comply with the requirements of the 'User Manual'. The angle between the plane of the wall bracket and the normal direction of the attachment surface should not exceed 8 degrees;. When the attachment device does not meet the requirements of the 'User Manual' due to conditions, its calculation sheet, design, and production materials should be confirmed by the manufacturer or reviewed by the technical leader of the installation unit,Saint EtienneElectric hydraulic folding elevator, and verified by experts.
Do not move after lifting, and do not lift until the four legs are firmly supported.
Setting requirements: For construction electric elevators with foundations installed on roof slabs, floors, or other lower suspended structures the bearing capacity of the foundation support structure should be checked. Click here to download the construction technical information for free. Basic drainage facilities should be installed.
High quality and low price.Setting requirements: The anti loosening and anti loosening parts between the connecting parts should comply with the provisions of the user manual and should not be replaced by other objects. For connecting bolts with pre tightening requirements, a torque wrench or special tool should be used to accurately tighten the bolts to the specified torque value according to the specified tightening sequence. When installing standard section connecting bolts, it is advisable to place the screw at the bottom and the nut at the top.
The safety bulletin board for construction electric elevators should be hung at the protective shed of the electric elevator, with a size of 8 meters by 2 meters.
Double layer steel mesh: The diameter of the steel bars is 12mm, with a spacing of 200mm.
The quality of the standard section should comply with the product manual and specification requirements.
discount.The foundation base or embedded parts should be fully embedded in the concrete foundation plate.
Construction electric elevators should be equipped with upper limit switches that are sensitive and reliable.
Work is essential, and the main protective accessories include safety belts, guardrails, protective covers, platforms and stairs, etc.
Saint Etienne.The foundation base or embedded parts should be fully embedded in the concrete foundation plate.
Operating cost advantage and low failure rate: Due to the use of advanced hydraulic systems and good methods, the operating failure rate can be reduced to a low level.
The angle between the wall bracket and the horizontal plane should comply with the requirements of the user manual.