KetaiAll electric small elevatorDifferent plays different roles

Setting requirements: The guide rail should be rigid and flexible components such as wire ropes or chains should not be used.

Installation and dismantling personnel and drivers should hold certificates to work.

Ketai.Non automatic reset upper and lower limit switches should be installed at both the upper and lower ends of the stroke, which should be able to cut off the power supply before the suspension cage and other mechanical stop devices (such as buffers),

The bearing capacity of the building structure at the attachment point of the wall bracket should meet the requirements specified in the user manual for construction electric elevators.

.Spiral electric lifting mechanism: With all the functions of a regular lifting platform the main feature is that the equipment occupies a small foundation pit and has a large stroke. The equipment has a height of only 200-500mm and a travel distance of up to 14m. It is particularly suitable for buildings with stages built on two or more floors due to space constraints.

News Abstract: The development of the lifting platform industry will continue to grow in recent years! With the continuous development of electric lifting machinery for high-altitude operations in recent years, the products of electric lifting platform vehicles have been continuously improved,KetaiSmall electric elevator platform, and various new technologies and materials have emerged, making the further development of lifting platform vehicles possible.

The use of a lifting platform as a tool for storing performance blankets, soft scenery, etc. In some theaters, there is a soft scenery storage lifting platform located at an appropriate location on the stage for the storage of blankets, soft scenery, it should be repaired by professional personnel as soon as possible. After the malfunction occurs when there is a major malfunction of the lifting platform, it should not be used again to avoid accidents,KetaiElectric rope climbing machine elevator, personnel and property losses.

The coaxiality between the motor shaft and the worm shaft in the aluminum alloy electric elevator drive device should be less than 0.1mm,KetaiScissor fork electric lifting platform, and there should be a 2mm gap at the shaft end to ensure that the motor bearings bear reasonable loads and reduce motor operating noise; electric

The spacing between wall brackets and the height of guide rails above the high attachment point should comply with the requirements of the user manual.

consumption.Setting requirements: The spacing of wall brackets along the vertical direction should comply with the provisions of the user manual.

The foundation base or embedded parts should be fully embedded in the concrete foundation plate.

Safety grounding device. In order to protect against electrical equipment. The metal casing of electrical equipment and the metal structure of electric elevators should be equipped with a safety grounding device. The grounding wire should operate multiple wires, and the neutral wire should not be arbitrarily held as a safety grounding wire. Its grounding resistance should not exceed 4 ohms; The power supply of the electric elevator can be cut off.

Double layer steel mesh: The diameter of the steel bars is 12mm, with a spacing of 200mm.

Interpretation and observation.Chain type electric lifting mechanism: With a good guiding mechanism, it can ensure that the equipment does not tilt during operation. Gear and rack electric lifting mechanism: precise transmission and high cost.

Items and other miscellaneous items.

Operating cost advantage and low failure rate: Due to the use of advanced hydraulic systems and good methods, the operating failure rate can be reduced to a low level.

Ketai.With the continuous improvement of urbanization level in China, the number of high-rise buildings in urban areas has sharply increased, and the height of buildings has also continued to grow. This has created a demand for high-altitude lifting platform vehicles. Therefore, in order to meet the needs of the domestic market and the public, all equipped with imported high-quality pump stations, which can also be selected according to customer requirements to meet customer ideal requirements.

Setting requirements: The landing door should be standardized and tooled.