portland Light electric elevatorWhat aspects of the operation should be paid attention to-World information network

The foundation base or embedded parts should be fully embedded in the concrete foundation plate.

Chain type electric lifting mechanism: With a good guiding mechanism, it can ensure that the equipment does not tilt during operation. Gear and rack electric lifting mechanism: precise transmission and high cost.

portland .Check the starter potential when the lifting table is not raised or the voltage is too low when the motor load is working. Voltage hydraulic range allowed&

Drainage measures need to be considered around the foundation. (Drain the accumulated water on the foundation).

.The foundation production and acceptance of electric elevators for foundation construction should comply with the user manual and regulatory requirements.

During normal operation, the horizontal distance between the closed cage door and the closed landing door should not exceed 150mm. Otherwise, measures should be taken to make it meet the requirements, or side protection devices at the entrance of the landing station that meet the requirements should be equipped. The distance between any opening between the side protection device and the hanging cage or landing door should not exceed 150mm.

Later, when there is a major malfunction of the lifting platform, it should be repaired by professional personnel as soon as possible. After the malfunction occurs,portland Decoration electric elevator,portland Fully electric scissor lift, it should not be used again to avoid accidents, personnel and property losses.

portland Light electric elevatorWhat aspects of the operation should be paid attention to

Later, when there is a major malfunction of the lifting platform, it should not be used again to avoid accidents, personnel and property losses.

Equal effect.

As a material loading and unloading equipment recognized by customers in the lifting platform, the guide rail hydraulic lifting platform is superior in terms of product, civil engineering, and operating costs. The editor of the electric elevator will provide a detailed analysis: the advantages of the product are that the equipment bears a large load, can achieve multiple points, and can be controlled up and down floors to achieve safe use.

middleman.Setting requirements: The installation and dismantling workers, electricians, low level doors can be used. Low level doors should meet the following requirements: the height of the door should be between 1m and 2m. And there should be at least protective railings, a half height middle crossbar, and a toe board at least 150mm above the ground.

Product line.The end height of the guide rail frame above the high attachment point should comply with the provisions of the user manual.

Construction electric elevators should be equipped with safety devices to prevent the cage from falling. The anti fall safety device should be functional at all times,portland Mobile hydraulic electric elevator, including installation, disassembly and before resetting after action. Fall arrest safety gear

For customers to use and operate the lifting platform for a long time, the editor briefly introduces how to maintain and repair the lifting platform: First of all, normal maintenance is mainly focused on prevention, especially if any damage or malfunction is detected and corrected or repaired in a timely manner. Careful inspection and maintenance at this time can save costs and avoid larger problems resulting in costly repairs.

portland .Implementing multiple shifts of homework should fill in and submit records according to regulations.

Setting requirements: When the distance between the outer edge of the construction electric elevator and the external overhead power line cannot meet the requirements of a small safety distance, the protective measures taken should comply with the specification requirements.