WiesbadenElect
WiesbadenMobil
WiesbadenElectCivil engineering advantages: The pit depth of the guide rail type lifting platform is generally around 150-300mm, and the top layer is not affected. It can be customized according to the location and environment.
During normal operation, the horizontal distance between the closed cage door and the closed landing door should not exceed 150mm. Otherwise, measures should be taken to make it meet the requirements, or side protection devices at the entrance of the landing station that meet the requirements should be equipped. The distance between any opening between the side protection device and the hanging cage or landing door should not exceed 150mm.
Wiesbaden.The up travel (limit) switch should be of the automatic reset type.
After the electric elevator passes the inspection, the user unit shall organize the leasing unit, installation unit, and supervision unit to conduct acceptance. For the implementation of construction general contracting, the acceptance shall be organized by the construction general contracting unit. The acceptance form should be signed by the relevant responsible person.
.Human improper operation is the main factor causing malfunctions in scissor type electric elevators. When stacking goods electric elevators should stack the goods neatly,WiesbadenElectric scissor type lifting platform, which is better than stacking them in the center of the cargo stacking area of the cargo elevator to avoid imbalance between the two ends of the stacking area. Eventually, during the operation of the electric elevator, it may cause the electric elevator to lose balance. After the goods are stacked completely, ropes should be used to lock the goods, so that they are not afraid of the goods during the lifting process; Careless; Scattered down
Tank oil temperature protection: When the oil temperature in the tank exceeds the standard setting value, the oil temperature protection device sends a signal to suspend the use of the elevator. The elevator can only be started when the oil temperature drops
Before operating the construction electric elevator routine inspections should be carried out according to regulations and inspection records should be filled out.
Double layer steel mesh: The diameter of the steel bars is 12mm,Wiesbaden2 meter electric elevator, with a spacing of 200mm.
During maintenance or when problems occur, the power supply should be cut off in a timely manner. After lifting, the aluminum alloy electric elevator should be firmly fixed before maintenance can be carried out. It is strictly prohibited to operate with defects to avoid accidents.
Later, when there is a major malfunction of the lifting platform, it should be repaired by professional personnel as soon as possible. After the malfunction occurs, which is an individual mechanism that is integrated with a safety clamp; The entrance and exit of the passenger compartment should be equipped with safety doors. Public places, family dormitories, and
Setting requirements: Drainage measures should be set up for the foundation of construction electric elevators to ensure smooth drainage.
Setting requirements: The verticality deviation of the installation of the guide rail frame of the construction electric elevator should comply with the requirements of the user manual and specifications, as specified in the above table.
Setting requirements: The wall bracket should use the manufacturer's matching standard products.
middleman.Construction electric elevators outside the lightning protection range
The safety overtravel of limit switches and upper limit switches should comply with regulatory requirements.
When applying a normal force of 300N to any position on either side of the door using a rigid 5000mm2 square or circular flat surface in the locked position of the landing door, the door should be able to withstand and have no deformation; - Deformation not exceeding 30mm; After the test, it worked normally.
Wiesbaden.When the foundation is set on the roof or floor structure, the bearing capacity of its supporting structure should be checked.
When the wall bracket cannot meet the requirements of the construction site, it should be designed and calculated separately.
The verticality of the guide rail frame should meet the requirements of the specifications.