qinghuangdaoEl
qinghuangdaoFuqinghuangdaoElevator electric elevator,
The safety bulletin board for construction electric elevators should be hung at the protective shed of the electric elevator, with a size of 8 meters by 2 meters.
Every theater is a public place with a large number of people, and safety considerations should be taken into account in stage design. According to relevant national regulations, in order to prevent accidents caused by the crushing of electric elevators or improper control by drivers. Electric elevators should be equipped with the following necessary safety devices to ensure that the car of the electric elevator stops rising or falling in a timely manner.
qinghuangdao.The movement of its related components is direct.
Horizontal lead screw mechanical electricity
.The foundation base or embedded parts should be fully embedded in the concrete foundation plate.
The distance between the electric hoist and overhead line in Electrical safety construction shall meet the specification requirements,qinghuangdaoSmall mobile electric elevator, otherwise protective measures shall be taken.
The foundation base or embedded parts should be fully embedded in the concrete foundation plate.
Drivers of construction electric elevators should hold special construction operations and are not allowed to operate without a certificate.
Check the starter potential when the lifting table is not raised or the voltage is too low when the motor load is working. Voltage hydraulic range allowed&
Setting requirements: When the distance between the outer edge of the construction electric elevator and the external overhead power line cannot meet the requirements of a small safety distance, the protective measures taken should comply with the specification requirements.
Standard requirements.Setting requirements: For construction electric elevators with foundations installed on roof slabs, floors, or other lower suspended structures, the bearing capacity of the foundation support structure should be checked. Click here to download the construction technical information for free. Basic drainage facilities should be installed.
In addition to ground protective fences, low level doors can be used. Low level doors should meet the following requirements: the height of the door should be between 1m and 2m. And there should be at least protective railings, a half height middle crossbar, and a toe board at least 150mm above the ground.
The L distance depends on the selected wall mount model.
When the distance between the outer edge of the construction electric elevator and the edge line of the external overhead power line cannot meet the requirements in the table above, effective protective measures should be taken.
packing.The connection method and angle between the wall bracket and the building structure should comply with the requirements of the user manual.
The installation position of the lower limit switch. The installation position of the lower limit switch should ensure that the contact plate triggers the switch when the rated load of the suspension cage decreases, causing the suspension cage to stop. At this time, the contact plate should also be close to the triggering of the lower limit switch
The landing door should meet the requirements of the specifications and achieve standardization.
qinghuangdao.The motor of the hydraulic guide rail lifting platform is set around the wellbore,qinghuangdaoElectric screw elevator, occupying a relatively small area, improving the utilization rate of the wellbore area.
Setting requirements: Each landing entrance should be equipped with a landing door, which should cover the opening with its full width, and should not open towards the lifting passage.
Model Example: Hanging Cage Specification: LABSC200/200TD3200x1500 Type I: 2900~3600 Type II: 2900~3600 Type V: 1800~250044003800 Technical Requirements: The load-bearing capacity of the foundation should be greater than P: P=(hanging cage weight+outer cage weight+total weight of guide rail frame+counterweight+load) x0.02 (kN).