HeimElectric e
HeimAutomatic The scaffolding of the parking platform should be laid tightly and firmly.
The net height of the landing door opening should not be less than 8m, and the difference between the net width and the outlet width of the cage door should not exceed 120mm. When the floor door is closed, except for the gap between the lower part of the door that should not exceed 35mm, the size of any through-hole and opening related to the distance between any door and adjacent moving parts, as well as the gap around the door or between parts, should comply with the provisions of Table 4 of 'Mechanical Safety - Safety Distance to Prevent Upper and Lower Limbs from Touching Dangerous Areas' GB23821-2009.
Heim.. The shutdown device (emergency stop switch) should be installed outside the ground protective fence; b) Pulley room (if any. Pulley room refers to a room where only pulleys or speed limiters and electrical equipment are installed; c) hanging cage top, if
The safety bulletin board for construction electric elevators should be hung at the protective shed of the electric elevator, with a size of 8 meters by 2 meters.
.There is no need to set up a computer room above the shaft like an elevator, and the top floor height can be installed at least 2.5 meters.
The safety notice board for construction electric elevators should be prominently placed on the hanging cage for the rated load capacity and rated number of passengers of the construction electric elevator. It is strictly prohibited to use construction electric elevators beyond the rated load capacity or rated number of passengers.
Setting requirements: The installation and dismantling workers, and other operators of construction electric elevators should have special construction operations.
Setting requirements: The installation and dismantling workers,HeimElectric elevator for balcony, electricians, and other operators of construction electric elevators should have special construction operations.
The movement of its related components is direct.
Safety performance: Electric elevators not only have the safety device of traditional traction elevators, but also have an overflow valve to prevent excessive system pressure during upward movement
Convenient and efficient.When the foundation is set on the roof or floor structure, the bearing capacity of its supporting structure should be checked.
Then,HeimElectric mobile elevator,HeimFully electric self-propelled elevator, the lifting platform platform platform that carries the load needs to be balanced, and no deviation of one side is allowed. The lifting of goods does not allow people to stand on both sides of the platform, and the lifting of goods should try to maintain a stable and uniform speed.
The scaffolding of the parking platform should be laid tightly and firmly.
Small safe operation distance: Circuit voltage (kV) of external power lines<11~1035~110220330~550 Small safe operation distance (m) 4681015 Setting requirements: A small safe distance should be maintained between the outer edge of the construction electric elevator and the edge of the external overhead power line.
Home page recommendation.Setting requirements: The spacing of wall brackets along the vertical direction should comply with the provisions of the user manual.
The magnetic directional valve returns to the fuel tank. To ensure stable landing of heavy objects and safe and reliable braking a balance valve is installed on the return oil circuit to balance the circuit and maintain pressure, so that the landing speed does not change due to heavy objects. It is adjusted by the saving valve
Human improper operation is the main factor causing malfunctions in scissor type electric elevators. When stacking goods, during the operation of the electric elevator which is better than stacking them in the center of the cargo stacking area of the cargo elevator to avoid imbalance between the two ends of the stacking area. Eventually, it may cause the electric elevator to lose balance. After the goods are stacked completely, ropes should be used to lock the goods, so that they are not afraid of the goods during the lifting process; Careless; Scattered down
Heim.Horizontal lead screw mechanical electricity
The landing door should meet the requirements of the specifications and achieve standardization.
Implementing multiple shifts of homework should fill in and submit records according to regulations.