KoboshburgGuid
KoboshburgElecBefore installation, the installation unit should confirm that the foundation, foundation bearing capacity,KoboshburgElectric scissor type lifting platform, embedded parts, and foundation drainage measures of the installed construction electric elevator and auxiliary heavy equipment comply with the requirements of the special construction plan for the installation and dismantling of the construction electric elevator based on the construction electric elevator foundation acceptance form, concealed engineering acceptance form, and other operators of construction electric elevators should have special construction operations.
.Setting requirements: The anti loosening and anti loosening parts between the connecting parts should comply with the provisions of the user manual and should not be replaced by other objects. For connecting bolts with pre tightening requirements, a torque wrench or special tool should be used to accurately tighten the bolts to the specified torque value according to the specified tightening sequence. When installing standard section connecting bolts, it is advisable to place the screw at the bottom and the nut at the top.
The safety distance between the outer edge of the upper part of the landing door and the moving parts of the electric elevator during normal operation should not be less than 0.75m; If the rated speed is not greater than 0.7m/s, the safety distance can be 0.40m.
The angle between the wall bracket and the horizontal plane should comply with the requirements of the user manual.
Mechanical devices controlled by cage movement should not be used to open or close the landing door.
Construction electric elevators should be equipped with lower limit switches that are sensitive and reliable.
Work is essential, and the main protective accessories include safety belts, guardrails, protective covers, platforms and stairs, etc.
Design brand.The motor of the hydraulic guide rail lifting platform is set around the wellbore, occupying a relatively small area, improving the utilization rate of the wellbore area.
When the door is closed, except for the gap between the lower part of the door that should not exceed 35mm, any through-hole and opening size related to the distance between any door and adjacent moving parts, as well as the gap around the door or the gap between parts, should comply with the provisions of Table 4 of GB 23821-2009.
The motor of the hydraulic guide rail lifting platform is set around the wellbore, occupying a relatively small area,KoboshburgDedicated electric elevator,Koboshburg6-meter electric elevator, improving the utilization rate of the wellbore area.
Human improper operation is the main factor causing malfunctions in scissor type electric elevators. When stacking goods, electric elevators should stack the goods neatly, which is better than stacking them in the center of the cargo stacking area of the cargo elevator to avoid imbalance between the two ends of the stacking area. Eventually during the operation of the electric elevator, it may cause the electric elevator to lose balance. After the goods are stacked completely, ropes should be used to lock the goods, so that they are not afraid of the goods during the lifting process; Careless; Scattered down
wholesaler.To meet the needs of stage craftsmanship and layout; Product; In the music and dance theater stage arranged in a zigzag pattern, auxiliary lifting platforms are often arranged in front, back, and right of the main stage lifting platform. The side and rear auxiliary lifting platforms are used for the smooth opening of the side platform and rear vehicle turntable, while the front auxiliary lifting platform is used to place the rear vehicle turntable near the platform entrance. The leveling lifting platform below the side platform and rear vehicle turntable can be used to level the platform after the side platform or rear vehicle turntable is driven out, so that the entire platform does not have a height difference, ensuring the safety of the cast members.
Before each shift of work, the safety devices of the construction electric elevator should be inspected to ensure sensitivity and reliability.
When the foundation is set on the roof or floor structure the bearing capacity of its supporting structure should be checked.
Koboshburg.The spacing between wall brackets and the height of guide rails above the high attachment point should comply with the requirements of the user manual.
Construction electric elevators should be equipped with cable guide frames and comply with regulatory requirements.
Double layer steel mesh: The diameter of the steel bars is 12mm, with a spacing of 200mm.