CasoriaElectric hydraulic elevatorWhat are the general sense of value materials

Safety grounding device. In order to protect against electrical equipment. The metal casing of electrical equipment and the metal structure of electric elevators should be equipped with a safety grounding device. The grounding wire should operate multiple wires, and the neutral wire should not be arbitrarily held as a safety grounding wire. Its grounding resistance should not exceed 4 ohms; The power supply of the electric elevator can be cut off.

Operating cost advantage and low failure rate: Due to the use of advanced hydraulic systems and good methods, the operating failure rate can be reduced to a low level.

Casoria.The safety overtravel of limit switches and upper limit switches should comply with regulatory requirements.

Use floor doors and cage door devices on construction sites where conditions permit.

.The advantages and disadvantages of several commonly used electric lifting mechanisms are as follows: hydraulic electric lifting mechanisms: using hydraulic technology,Casoria2 meter electric lifting platform, smooth lifting and low noise.

Setting requirements: The spacing of wall brackets along the vertical direction should comply with the provisions of the user manual.

The use of standard section connecting bolts should comply with the user manual and specification requirements.

Horizontal lead screw mechanical electricity

Construction electric elevators should be equipped with lower limit switches that are sensitive and reliable.

Setting requirements: The layout and installation of all cables and wiring of electric elevators should be able to prevent mechanical damage.

total cost.Tank oil temperature protection: When the oil temperature in the tank exceeds the standard setting value, the oil temperature protection device sends a signal to suspend the use of the elevator. The elevator can only be started when the oil temperature drops

During loading and unloading,CasoriaElectric elevator 6 meters, the horizontal distance between the edge of the cage door and the edge of the landing station should not exceed 50mm.

Setting requirements: For construction electric elevators that operate in multiple shifts, the handover system should be implemented, and drivers should fill out the handover record form according to the standard requirements. The driver should conduct a pre shift inspection and confirm that there are no errors before starting the machine for operation.

There is no need to set up a computer room above the shaft like an elevator, and the top floor height can be installed at least 2.5 meters.

Lets see.Braking. The brake limit switch for partial motion control of the electric hoist traction machine. Assembly that restricts the operation of the lift car when it is opened to a high or low position; If the limit switch controls the overtravel switch. When the car travels to a high or low position, it will take on the function of raising or lowering. In order to prevent the lift car from crashing or sinking, stage equipment should be dismantled with over travel switches that can cut off power and cannot be automatically reset, and installed in the machine room, rather than in the shaft; A buffer should be installed that can absorb the energy of the moving mechanism and reduce impact.

Check whether the sealing of components such as the oil cylinder,CasoriaElectric elevator 10 meters, oil pipe, and motor of the aluminum alloy electric elevator is good and whether there is any air leakage.

The safety bulletin board for construction electric elevators should be hung at the protective shed of the electric elevator, with a size of 8 meters by 2 meters.

Casoria.When the foundation is set on the roof or floor structure, the bearing capacity of its supporting structure should be checked.

Setting requirements: The main connection methods between the wall bracket and the building include: connecting the wall bracket with the embedded parts on the wall; Fix with wall bolts; Embedded bolts; Welding with steel structures.

Double layer steel mesh: The diameter of the steel bars is 12mm, with a spacing of 200mm.