Agnel sur Sein
Agnel sur Sein
Agnel sur Seina hydraulic control one-way valve
To ensure safe and reliable braking of the lifting platform and prevent accidents, also known as a hydraulic lock, is added to ensure safe self-locking in the event of an accidental rupture of the hydraulic pipeline. An overload sound control alarm has been installed to distinguish between overload or equipment failure. Electrical system explosion-proof button SB1&flash; The rotation of the SB6 motor and the commutation of the explosion-proof electromagnetic directional valve are used to maintain load increase or decrease, and the main protective accessories include safety belts, guardrails, protective covers, platforms and stairs, etc.
Agnel sur Seine.When adding hydraulic oil, we can extend the oil cylinder to the high position for filling. When filling,Agnel sur SeineSmall electric screw elevator, the lifting platform should not exceed the high position, and maintain it between the two.
The spacing between wall brackets and the height of guide rails above the high attachment point should comply with the requirements of the user manual.
.Speed limit wire rope switch. When the speed limit wire rope trips or breaks. Make the electric elevator unable to start.
Setting requirements: The anti loosening and anti loosening parts between the connecting parts should comply with the provisions of the user manual and should not be replaced by other objects. For connecting bolts with pre tightening requirements, a torque wrench or special tool should be used to accurately tighten the bolts to the specified torque value according to the specified tightening sequence. When installing standard section connecting bolts, it is advisable to place the screw at the bottom and the nut at the top.
Steel wire ropes, pulleys, and counterweight steel wire ropes shall comply with the following regulations: the characteristics of steel wire ropes shall comply with the requirements of General Purpose Steel Wire Ropes GB/T20118; Maintenance, wear, deformation, and corrosion of steel wire ropes
When the wall bracket cannot meet the requirements of the construction site it should be designed and calculated separately.
Construction electric elevators should be equipped with upper limit switches that are sensitive and reliable.
The safety distance between the outer edge of the upper part of the landing door and the moving parts of the electric elevator during normal operation should not be less than 0.75m; If the rated speed is not greater than 0.7m/s, the safety distance can be 0.40m.
Production department.Setting requirements: The spacing of wall brackets along the vertical direction should comply with the provisions of the user manual.
When the landing door is closed, the full width of the lifting passage opening should be covered.
Speed limiter. To prevent the driving speed from exceeding the normal speed. A speedometer should be installed (not required for floors below or including the second floor), which is an individual mechanism that is integrated with a safety clamp; The entrance and exit of the passenger compartment should be equipped with safety doors. Public places, family dormitories, and
Electric elevators used in various places.
Affordable price.Before operating the construction electric elevator, routine inspections should be carried out according to regulations and inspection records should be filled out.
The shutdown device (emergency stop switch) should be non automatic reset type.
Use floor doors and cage door devices on construction sites where conditions permit.
Agnel sur Seine.Speed limit wire rope switch. When the speed limit wire rope trips or breaks. Make the electric elevator unable to start.
The entrance of each landing platform must be equipped with a landing door, which must open towards the landing platform side,Agnel sur SeineElectric tricycle elevator,Agnel sur SeineElectric elevator for exterior wall decoration, and the door bolt must be set on the side next to the construction electric elevator.
It is understood that the scissor type lifting platform is a widely used specialized equipment for high-altitude operations. Its shear fork mechanical structure provides high stability for the lifting platform, wide working platform, and high load-bearing capacity, making the range of high-altitude operations larger and suitable for multiple people working simultaneously. The lifting power is divided into 24V, 220V or 380V power supplies, diesel engines, using Italian and domestic hydraulic pump stations, and the table top is equipped with anti slip insulation buckle plates, which have anti slip, insulation, and safety features. Please rest assured to use.