WehrovoElectri
WehrovoAutomatSetting requirements: The installation and dismantling workers, electricians, and other operators of construction electric elevators should have special construction operations.
Emergency manual valve: In case of power failure, it can cause the car to descend to the nearest floor position and open the door
Wehrovo.Setting requirements: Buffers should be installed below the suspension cage and counterweight running channel.
From the above comparison,WehrovoSmall electric automatic elevator, it can be seen that hydraulic electric lifting mechanisms have stable lifting, low noise, long service life, large load bearing capacity, and are relatively simple making them suitable for use in stage equipment.
.From the perspective of the safety performance of the machinery itself, mechanical components may fall off or be damaged due to various factors. This problem depends on regular inspection and maintenance of the machinery
Setting requirements: The landing door should be standardized and tooled.
The advantages and disadvantages of several commonly used electric lifting mechanisms are as follows: hydraulic electric lifting mechanisms: using hydraulic technology, smooth lifting and low noise.
The foundation base or embedded parts should be fully embedded in the concrete foundation plate.
When adding hydraulic oil,WehrovoElevator platform electric, we can extend the oil cylinder to the high position for filling. When filling, the lifting platform should not exceed the high position, and then retract the oil cylinder back to the low position to check if the hydraulic oil level is lower than the low position, and maintain it between the two.
Setting requirements: The guide rail should be rigid and flexible components such as wire ropes or chains should not be used.
market.Setting requirements: For construction electric elevators that operate in multiple shifts, the handover system should be implemented,WehrovoFully automatic elevator electric, and drivers should fill out the handover record form according to the standard requirements. The driver should conduct a pre shift inspection and confirm that there are no errors before starting the machine for operation.
The scaffolding of the parking platform should be laid tightly and firmly.
The counterweight guide rail should meet the specification requirements.
The bearing capacity of the ground under the concrete foundation plate should be greater than 0.15Mpa.
How many?.The scaffolding of the parking platform should be laid tightly and firmly.
Construction electric elevators should be equipped with travel limit switches, as follows: automatic reset type upper and lower limit switches should be installed on construction electric elevators, but the upper and lower limit switches should not be triggered as high
The motor of the hydraulic guide rail lifting platform is set around the wellbore occupying a relatively small area, improving the utilization rate of the wellbore area.
Wehrovo.When the landing door is closed, the full width of the lifting passage opening should be covered.
Pipeline rupture valve: When the hydraulic system pipeline ruptures and the car stalls and descends, the landing door shall not be opened.