Setting requirements: Each landing entrance should be equipped with a landing door, which should cover the opening with its full width, and should not open towards the lifting passage.
Setting requirements: The spacing of wall brackets along the vertical direction should comply with the provisions of the user manual.
Li Shi.Installation position of upper limit switch: Under normal working conditions,Li ShiCustomized electric elevator, the distance between the upper limit switch and the upper limit switch is 0.15m for SC type construction electric elevators and 0.15m for SS type construction electric elevators (person)
Setting requirements: The anti loosening and anti loosening parts between the connecting parts should comply with the provisions of the user manual and should not be replaced by other objects. For connecting bolts with pre tightening requirements, a torque wrench or special tool should be used to accurately tighten the bolts to the specified torque value according to the specified tightening sequence. When installing standard section connecting bolts, it is advisable to place the screw at the bottom and the nut at the top.
.The use of standard section connecting bolts should comply with the user manual and specification requirements.
During normal operation, the horizontal distance between the closed cage door and the closed landing door should not exceed 150mm. Otherwise,Li Shi3 meter high electric elevator, measures should be taken to make it meet the requirements, or side protection devices at the entrance of the landing station that meet the requirements should be equipped. The distance between any opening between the side protection device and the hanging cage or landing door should not exceed 150mm.
Setting requirements: The guide rail should be rigid and flexible components such as wire ropes or chains should not be used.
When the horizontal distance between the edge of the cage and the edge of the landing or between the cage and the landing door is greater than 150mm and there is no effective protection from other structures, the side protection device for the landing entrance should be equipped.
The stopper bearing of the mechanism is kept intact.
Implementing multiple shifts of homework should fill in and submit records according to regulations.
Inspection environment.Double layer steel mesh: The diameter of the steel bars is 12mm, with a spacing of 200mm.
The scissor type electric elevator is a widely used high-altitude operation special equipment. Its scissor mechanical structure ensures high stability of the lifting platform, wide working platform, and high bearing capacity making the high-altitude operation range wider and suitable for multiple people to work simultaneously. It makes high-altitude operation more efficient and safer
Operating cost advantage and low failure rate: Due to the use of advanced hydraulic systems and good methods, it can automatically cut off the oil circuit and stop descent
how.With the continuous improvement of urbanization level in China, the number of high-rise buildings in urban areas has sharply increased, and the height of buildings has also continued to grow. This has created a demand for high-altitude lifting platform vehicles. Therefore, in order to meet the needs of the domestic market and the public, efforts will inevitably be made to design and produce high-altitude lifting platform vehicles.
The detailed reason why water cannot be used to flush the hydraulic station is that doing so will corrode the oil tank in the hydraulic station, and once water is mixed in the hydraulic station, it will simply form pipeline corrosion, water vaporization, and other phenomena that can cause adverse effects or results for hydraulic electric elevators. Therefore, it is necessary to prevent such actions to ensure the normal operation and service life of the hydraulic station.
When the distance between the outer edge of the construction electric elevator and the edge line of the external overhead power line cannot meet the requirements in the table above, effective protective measures should be taken.
Li Shi.Construction electric elevators should be equipped with cable guide frames and comply with regulatory requirements.
Manual pump: When the system malfunctions, the manual pump can be operated to pump high-pressure oil to raise the car to the nearest floor position
Drivers of construction electric elevators should hold special construction operations and are not allowed to operate without a certificate.