JiangxiElectri
JiangxiSmall cModel Example: Hanging Cage Specification: LABSC200/200TD3200x1500 Type I: 2900~3600 Type II: 2900~3600 Type V: 1800~250044003800 Technical Requirements: The load-bearing capacity of the foundation should be greater than P: P=(hanging cage weight+outer cage weight+total weight of guide rail frame+counterweight+load) x0.02 (kN).
The end height of the guide rail frame above the high attachment point should comply with the provisions of the user manual.
Jiangxi.The magnetic directional valve returns to the fuel tank. To ensure stable landing of heavy objects and safe and reliable braking, a balance valve is installed on the return oil circuit to balance the circuit and maintain pressure, so that the landing speed does not change due to heavy objects. It is adjusted by the saving valve
The counterweight guide rail should meet the specification requirements.
.Tank oil temperature protection: When the oil temperature in the tank exceeds the standard setting value, it should be designed separately. The design of the wall bracket should meet the requirements of component stiffness, strength, stability, etc. and the production should meet the design requirements.
There is no need to set up a computer room above the shaft like an elevator, and the top floor height can be installed at least 2.5 meters.
Installation verticality deviation guide rail frame erection height, h/mH≤ 7070100150H& gt; 200 verticality deviation/mm≤ (1/100h≤ 70≤ 90≤ 110≤ 130 pairs of steel wire rope construction electric elevators, the verticality deviation of the guide rail frame should not exceed (5/1000) h.
Is the water cooling and air cooling of the hydraulic station the same?
Setting requirements: The landing door should be standardized and tooled.
management.The bearing capacity of the ground under the concrete foundation plate should be greater than 0.15Mpa.
In addition to ground protective fences, low level doors can be used. Low level doors should meet the following requirements: the height of the door should be between 1m and 2m. And there should be at least protective railings, a half height middle crossbar, and a toe board at least 150mm above the ground.
Setting requirements: The wall bracket should use the manufacturer's matching standard products.
When the landing door is closed, the full width of the lifting passage opening should be covered.
Statistics.To meet the needs of stage craftsmanship and layout; Product; In the music and dance theater stage arranged in a zigzag pattern, back, left, and right of the main stage lifting platform. The side and rear auxiliary lifting platforms are used for the smooth opening of the side platform and rear vehicle turntable,JiangxiElectric hydraulic elevator, while the front auxiliary lifting platform is used to place the rear vehicle turntable near the platform entrance. The leveling lifting platform below the side platform and rear vehicle turntable can be used to level the platform after the side platform or rear vehicle turntable is driven out,JiangxiScissor fork electric elevator, so that the entire platform does not have a height difference, ensuring the safety of the cast members.
Stop.
From the above comparison,Jiangxi3 meter small electric elevator, it can be seen that hydraulic electric lifting mechanisms have stable lifting low noise, long service life, large load bearing capacity, and are relatively simple, making them suitable for use in stage equipment.
Jiangxi.The counterweight guide rail should meet the specification requirements.
Tank oil temperature protection: When the oil temperature in the tank exceeds the standard setting value, the oil temperature protection device sends a signal to suspend the use of the elevator. The elevator can only be started when the oil temperature drops
Tank oil temperature protection: When the oil temperature in the tank exceeds the standard setting value, the oil temperature protection device sends a signal to suspend the use of the elevator. The elevator can only be started when the oil temperature drops