lush mountainTen meter electric elevatorHow to operate the manufacturing process

announcer:hp935HP175192871 release time:2024-06-25 17:42:08

occupying a relatively small area

The motor of the hydraulic guide rail lifting platform is set around the wellbore, improving the utilization rate of the wellbore area.

Small safe operation distance: Circuit voltage (kV) of external power lines<11~1035~110220330~550 Small safe operation distance (m) 4681015 Setting requirements: A small safe distance should be maintained between the outer edge of the construction electric elevator and the edge of the external overhead power line.

lush mountain.The upward movement of the hydraulic cylinder involves lifting heavy objects, and the return oil from the upper end of the hydraulic cylinder returns to the oil tank through the explosion-proof electromagnetic directional valve. The additional pressure relief valve is used for adjustment, and the pressure gauge reads the value when observing the pressure gauge

Low level doors should be equipped with interlocking devices that can verify their closed and locked positions. The action of this interlocking device should be at the entrance of the cage. Simple use should not interfere with the operation of the interlocking device. The attached wall bracket should use matching standard products. When the wall bracket cannot meet the requirements of the construction site,lush mountainElectric hydraulic elevator, strength, stability, etc., and the production should meet the design requirements.

.Acceptance: Concrete strength grade C30,lush mountainMobile small electric elevator, strength testing report.

Double layer steel mesh: The diameter of the steel bars is 12mm, with a spacing of 200mm.

Small safe operation distance: Circuit voltage (kV) of external power lines<11~1035~110220330~550 Small safe operation distance (m) 4681015 Setting requirements: A small safe distance should be maintained between the outer edge of the construction electric elevator and the edge of the external overhead power line.


lush mountainTen meter electric elevatorHow to operate the manufacturing process



Setting requirements: The landing door should be standardized and tooled.

Lowering platform, vehicle mounted lifting platform, self-propelled lifting platform, diesel engine curved arm self-propelled lifting platform, folding arm lifting platform cylinder sleeve lifting platform, and special

Implementing multiple shifts of homework should fill in and submit records according to regulations.

Focus on Development.From the above comparison, it can be seen that hydraulic electric lifting mechanisms have stable lifting, low noise, long service life, large load bearing capacity, and are relatively simple, making them suitable for use in stage equipment.

Safety performance: Electric elevators not only have the safety device of traditional traction elevators, but also have an overflow valve to prevent excessive system pressure during upward movement

The oil cylinder and sealing components are made of imported components to solve the problem of unstable oil pressure and oil leakage of components for customers.


lush mountainTen meter electric elevatorHow to operate the manufacturing process



When applying a normal force of 300N to any position on either side of the door using a rigid 5000mm2 square or circular flat surface in the locked position of the landing door,lush mountainSmall and simple electric elevator, the door should be able to withstand and have no deformation; - Deformation not exceeding 30mm; After the test, it worked normally.

Quality inspection report.The landing door should be in a normally closed state. Without the permission of the construction electric elevator driver, the landing door shall not be opened.

Check the starter potential when the lifting table is not raised or the voltage is too low when the motor load is working. Voltage hydraulic range allowed&

Emergency manual valve: In case of power failure, it can cause the car to descend to the nearest floor position and open the door

lush mountain.The safety notice board for construction electric elevators should be prominently placed on the hanging cage for the rated load capacity and rated number of passengers of the construction electric elevator. It is strictly prohibited to use construction electric elevators beyond the rated load capacity or rated number of passengers.

The scaffolding of the parking platform should be laid tightly and firmly.

The oil cylinder and sealing components are made of imported components to solve the problem of unstable oil pressure and oil leakage of components for customers.