JinyuanElectri
JinyuanUsed elConstruction electric elevators should be equipped with cable guide frames and comply with regulatory requirements.
Stage equipment safety door. To prevent personnel from extending their heads, hands,JinyuanElectric light lift, and feet out of the shaft and objects from falling into the vertical shaft. Its vertical position should be closed, its cabin should be full of doors,JinyuanElectric elevator mechanism, and the height of the hoistway (hall door) should not be less than 8 meters; The electric door opening and closing switches should be removed from the vertical and passenger compartment doors. In order to prevent accidents caused by vertical, passenger car doors,JinyuanSmall and simple electric elevator, and car roof doors not being closed.; Door interlocks should be installed on both the vertical and passenger compartment doors.
Jinyuan.Is the water cooling and air cooling of the hydraulic station the same?
With the continuous improvement of urbanization level in China, the number of high-rise buildings in urban areas has sharply increased, and the height of buildings has also continued to grow. This has created a demand for high-altitude lifting platform vehicles. Therefore, in order to meet the needs of the domestic market and the public, efforts will inevitably be made to design and produce high-altitude lifting platform vehicles.
.The end height of the guide rail frame above the high attachment point should comply with the provisions of the user manual.
Human improper operation is the main factor causing malfunctions in scissor type electric elevators. When stacking goods, electric elevators should stack the goods neatly, which is better than stacking them in the center of the cargo stacking area of the cargo elevator to avoid imbalance between the two ends of the stacking area. Eventually, during the operation of the electric elevator, it may cause the electric elevator to lose balance. After the goods are stacked completely, so that they are not afraid of the goods during the lifting process; Careless; Scattered down
The safety bulletin board for construction electric elevators should be hung at the protective shed of the electric elevator, with a size of 8 meters by 2 meters.
The safety notice board for construction electric elevators should be prominently placed on the hanging cage for the rated load capacity and rated number of passengers of the construction electric elevator. It is strictly prohibited to use construction electric elevators beyond the rated load capacity or rated number of passengers.
The isolation and buffering rubber in various parts of the aluminum alloy electric elevator drive device are intact and tightly fitted.
The scissor type electric elevator is a widely used high-altitude operation special equipment. Its scissor mechanical structure ensures high stability of the lifting platform, wide working platform, and high bearing capacity, making the high-altitude operation range wider and suitable for multiple people to work simultaneously. It makes high-altitude operation more efficient and safer
quality index.Setting requirements: For construction electric elevators that operate in multiple shifts, the handover system should be implemented, low level doors can be used. Low level doors should meet the following requirements: the height of the door should be between 1m and 2m. And there should be at least protective railings, a half height middle crossbar, and a toe board at least 150mm above the ground.
Pipeline rupture valve: When the hydraulic system pipeline ruptures and the car stalls and descends, it can automatically cut off the oil circuit and stop descent
Setting requirements: The foundation and foundation of the construction electric elevator should meet the requirements of the user manual. Before installing the construction electric elevator the foundation should be inspected and accepted according to the requirements of the specifications. Only after passing the inspection can the installation be carried out.
Quality inspection report.High lifting height, using side mounted oil cylinders, stable operation, noise free easy maintenance, and longer service life.
The inner bearing of the roller in the device is in good condition, and a complete grease film surface is maintained between the curved surface of the roller and the main chord of the aluminum alloy electric elevator. A good grease film surface can reduce wear and noise
Installation and dismantling personnel and drivers should hold certificates to work.
Jinyuan.The foundation base or embedded parts should be fully embedded in the concrete foundation plate.
The bearing capacity of the building structure at the attachment point of the wall bracket should meet the requirements specified in the user manual for construction electric elevators.
The foundation production and acceptance of electric elevators for foundation construction should comply with the user manual and regulatory requirements.